Searched full:transceivers (Results 1 – 25 of 27) sorted by relevance
12
29 up to 4 transceivers.44 up to 4 transceivers.52 up to 16 transceivers.60 up to 16 transceivers.68 up to 16 transceivers.
5 This binding is to be used by all the usb transceivers which are built-in
5 This binding is to be used by all the usb transceivers which are an external
4 # Common fields for CAN transceivers
6 This binding is to be used by the STM32U5xx transceivers which are built-in
20 Enable support for GPIO controlled CAN transceivers.
56 used together with noe pin to enable/disable transceivers.89 Optional pin to disable all bus transceivers if any are present.
29 up to 4 transceivers.
22 - 2 x 4-lane MIPI camera/display transceivers
23 - Two CAN transceivers
63 for all transceivers. This property must be used with tx-pwr-min and
211 https://www.semtech.com/products/wireless-rf/lora-transceivers/sx1276
184 …www.marvell.com/content/dam/marvell/en/public-collateral/transceivers/marvell-phys-transceivers-al…185 …www.marvell.com/content/dam/marvell/en/public-collateral/transceivers/marvell-phys-transceivers-al…
9 * @brief Definitions for IEEE 802.3, Section 2 MII compatible PHY transceivers
159 .. _Semtech SX1276: https://www.semtech.com/products/wireless-rf/lora-transceivers/sx1276
246 .. _Semtech SX1276: https://www.semtech.com/products/wireless-rf/lora-transceivers/sx1276
242 controllers/transceivers, and properties related to them.
234 /* Enable gpio to control the CAN transceivers and LEDs */
148 Note that this board does not currently come with CAN transceivers installed for
27 - CAN transceivers
26 - CAN transceivers
1386 * register at once will result in leaving the USB transceivers in usb_change_state()1390 * PD_SYS and resetting the controller along with its transceivers). in usb_change_state()
3 Atmel AT86RF2XX Transceivers
482 * Added support for coexistence with other transceivers.
641 * Added optional ``min-bitrate`` devicetree property for CAN transceivers.
