Searched full:io2 (Results 1 – 21 of 21) sorted by relevance
| /Zephyr-latest/dts/bindings/gpio/ |
| D | digilent,pmod.yaml | 14 1 IO2 IO6 5
28 1 IO2
|
| /Zephyr-latest/boards/st/stm32h735g_disco/ |
| D | pmod_connector.dtsi | 14 <1 0 &gpiof 7 0>, /* IO2 */
|
| /Zephyr-latest/boards/st/stm32h747i_disco/ |
| D | pmod_connector.dtsi | 14 <1 0 &gpioc 3 0>, /* IO2 */
|
| /Zephyr-latest/boards/adi/sdp_k1/ |
| D | adi_sdp_120pin_connector.dtsi | 72 <1 0 &sdp_k1_120_hdr SDP_120_SPI_MISO 0>, // IO2
88 <1 0 &sdp_k1_120_hdr SDP_120_UART_TX 0>, // IO2
|
| /Zephyr-latest/dts/bindings/qspi/ |
| D | nxp,s32-qspi.yaml | 125 a-io2-idle-high:
128 Set if the logic level of IO2 signal output of this controller must be
|
| /Zephyr-latest/boards/renesas/ek_ra8m1/ |
| D | ek_ra8m1.dts | 73 <1 0 &ioport6 9 0>, /* IO2 */
88 <1 0 &ioporta 3 0>, /* IO2 */
|
| /Zephyr-latest/soc/espressif/common/ |
| D | Kconfig.spiram | 217 ESP32 pin "SD_DATA_3" or SPI flash pin "IO2") is not specified in eFuse. The psram only has QPI
|
| /Zephyr-latest/include/zephyr/dt-bindings/pinctrl/ |
| D | nrf-pinctrl.h | 135 /** QSPI IO2 */
|
| /Zephyr-latest/boards/fanke/fk750m1_vbt6/doc/ |
| D | index.rst | 93 - QuadSPI NCS/CLK/IO0/IO1/IO2/IO3 : PB6/PB2/PD11/PD12/PE2/PD13 (NOR Flash)
|
| /Zephyr-latest/boards/fanke/fk7b0m1_vbt6/doc/ |
| D | index.rst | 112 - QuadSPI NCS/CLK/IO0/IO1/IO2/IO3 : PB6/PB2/PD11/PD12/PE2/PD13 (NOR Flash)
|
| /Zephyr-latest/boards/espressif/esp32_ethernet_kit/doc/ |
| D | index.rst | 376 IO2,,,,IO2,
|
| /Zephyr-latest/drivers/pinctrl/ |
| D | pinctrl_nrf.c | 337 NRF_PSEL_QSPI(reg, IO2) = psel; in pinctrl_configure_pins()
|
| /Zephyr-latest/boards/weact/mini_stm32h743/doc/ |
| D | index.rst | 120 - QuadSPI CLK/NCS/IO0/IO1/IO2/IO3 : PB2/PB6/PD11/PD12/PE2/PD13 (NOR Flash memory)
|
| /Zephyr-latest/boards/weact/mini_stm32h7b0/doc/ |
| D | index.rst | 121 - QuadSPI CLK/NCS/IO0/IO1/IO2/IO3 : PB2/PB6/PD11/PD12/PE2/PD13 (NOR Flash memory)
|
| /Zephyr-latest/boards/ezurio/mg100/doc/ |
| D | index.rst | 126 IO2 = P0.22
|
| /Zephyr-latest/boards/st/nucleo_f722ze/doc/ |
| D | index.rst | 158 - IO2: PE2 (CN10 pin 25)
|
| /Zephyr-latest/scripts/utils/ |
| D | pinctrl_nrf_migrate.py | 602 "io2": "QSPI_IO2",
|
| /Zephyr-latest/samples/drivers/espi/src/ |
| D | main.c | 281 * will act as IO2/IO3. We will write the volatile QE bit for less in spi_saf_init()
|
| /Zephyr-latest/boards/espressif/esp_wrover_kit/doc/ |
| D | index.rst | 241 | Camera, LED, Boot | IO0 | IO2 | LED, MicroSD |
|
| /Zephyr-latest/boards/snps/hsdk/doc/ |
| D | index.rst | 265 | IO2 | gpio[16] | - | - |
|
| /Zephyr-latest/boards/snps/hsdk4xd/doc/ |
| D | index.rst | 262 | IO2 | gpio[16] | - | - |
|
