Searched refs:low (Results 726 – 750 of 857) sorted by relevance
1...<<21222324252627282930>>...35
| /Zephyr-latest/dts/arm64/intel/ |
| D | intel_socfpga_agilex5.dtsi | 120 active-low;
|
| /Zephyr-latest/dts/arm/nxp/ |
| D | nxp_mcxw71.dtsi | 336 /* pwrlvl 0 is slow speed low power, 1 is opposite */
|
| /Zephyr-latest/boards/norik/octopus_io_board/doc/ |
| D | index.rst | 9 development and prototyping of low-power IoT applications.
|
| /Zephyr-latest/boards/nxp/mimxrt1010_evk/doc/ |
| D | index.rst | 141 When power management is enabled, the 32 KHz low frequency
|
| /Zephyr-latest/tests/drivers/build_all/sensor/ |
| D | spi.dtsi | 217 low-threshold = <6579>;
|
| /Zephyr-latest/boards/atmel/sam/sam_v71_xult/doc/ |
| D | index.rst | 20 - WM8904 low power stereo audio codec
|
| /Zephyr-latest/boards/nxp/mimxrt1064_evk/doc/ |
| D | index.rst | 299 When power management is enabled, the 32 KHz low frequency
329 When the device transitions into low power states, the debugger may be
|
| /Zephyr-latest/dts/arm/nuvoton/npcx/ |
| D | npcx7.dtsi | 15 /* NPCX7 series low-voltage io controls mapping table */
|
| /Zephyr-latest/boards/renesas/ek_ra8m1/doc/ |
| D | index.rst | 23 Additional low precision clocks are avaialbe internal to the RA8M1 MCU
|
| /Zephyr-latest/boards/u-blox/ubx_bmd360eval/doc/ |
| D | index.rst | 46 high-frequency oscillator at 32MHz. There is also a low frequency
|
| /Zephyr-latest/boards/snps/iotdk/doc/ |
| D | index.rst | 11 SMIC's 55-nm ultra-low power process, and a rich set of peripherals commonly
|
| /Zephyr-latest/doc/build/dts/ |
| D | intro-input-output.rst | 93 A low-level DTS parsing library.
|
| /Zephyr-latest/subsys/net/lib/ptp/ |
| D | msg.c | 55 msg->timestamp.protocol._sec.low = ntohl(ts->seconds_low); in msg_timestamp_post_recv()
|
| /Zephyr-latest/boards/96boards/argonkey/doc/ |
| D | index.rst | 176 FTDI chip. The UART pins on ArgonKey can be found on the P3 low speed
|
| /Zephyr-latest/boards/adi/eval_adin2111ebz/doc/ |
| D | index.rst | 7 low power 10BASE-T1L 2-Port Ethernet switch. The evaluation board provides 2 10BASE-T1L channels
|
| /Zephyr-latest/boards/adi/max32662evkit/doc/ |
| D | index.rst | 7 ultra-low power, highly integrated 32-bit microcontroller designed
|
| /Zephyr-latest/boards/actinius/icarus_som_dk/doc/ |
| D | index.rst | 9 a low-power 3-axis accelerometer and an on-board eSIM.
|
| /Zephyr-latest/boards/ezurio/pinnacle_100_dvk/doc/ |
| D | index.rst | 21 low-power LTE connection.
|
| /Zephyr-latest/doc/hardware/pinctrl/ |
| D | index.rst | 21 debouncing, low-power modes, etc.
70 depending on the operating conditions, for example, to enable a low-power mode
117 | | | the device is in low |
|
| /Zephyr-latest/subsys/bluetooth/controller/ |
| D | Kconfig.ll_sw_split | 284 bool "CIS creation policy for low latency"
287 Select this option to use low latency policy for CIS creation. This
885 Use low latency non-negotiating event preemption. This reduces
1145 bool "Allow low latency connection intervals"
1147 Allow low latency connection intervals.
1155 Set low latency tIFS value.
1204 bool "Ticker low latency mode"
|
| /Zephyr-latest/boards/renesas/ek_ra8d1/doc/ |
| D | index.rst | 23 Additional low precision clocks are avaialbe internal to the RA8D1 MCU
|
| /Zephyr-latest/boards/renesas/mck_ra8t1/doc/ |
| D | index.rst | 197 …/rtk0em0000s04020bj-mci-lv-1-renesas-flexible-motor-control-inverter-board-low-voltage-48v10a-thre…
|
| /Zephyr-latest/boards/seeed/xiao_esp32c6/doc/ |
| D | index.rst | 8 and a low-power (LP) 32-bit RISC-V processor, which can be clocked up to 20 MHz.
|
| /Zephyr-latest/samples/net/gptp/ |
| D | README.rst | 85 as the default value 800 is too low if you run the gPTP in FRDM-K64F.
|
| /Zephyr-latest/boards/u-blox/ubx_bmd330eval/doc/ |
| D | index.rst | 48 high-frequency oscillator at 32MHz. There is also a low frequency
|
1...<<21222324252627282930>>...35
