Searched refs:CMD (Results 1 – 20 of 20) sorted by relevance
13 int "BTP CMD threads stack size."16 Stack size in byte used by the BTP CMD thread.
252 config->base->CMD = I2C_CMD_ACK; in i2c_gecko_isr()268 config->base->CMD = I2C_CMD_ACK; in i2c_gecko_isr()
127 i2c->CTRLB.bit.CMD = 3; in i2c_sam0_terminate_on_error()178 i2c->CTRLB.bit.CMD = 3; in i2c_sam0_isr()196 i2c->CTRLB.bit.CMD = 3; in i2c_sam0_isr()
121 15 ADC channels. This value corresponds to how many of the CMD
80 p_fmc->CMD = cmd; in get_cmd_status()
61 - SDMMC1 D0..D4/CLK/CMD : PC8/PC9/PC10/PC11/PC12/PD2
68 - CMD: PD2 (CN8 pin 12)
371 config->base->CMD = (uint32_t) usartEnable; in spi_silabs_usart_init()
76 | D9 | CMD/RDY | SPI |
148 cmd = IMU_BOSCH_BMI323_REG_VALUE(CMD, CMD, SOFT_RESET); in bosch_bmi323_soft_reset()
94 - SDMMC_1 D0/D1/D2/D3/CK/CD/CMD: PC8/PC9/PC10/PC11/PC12/PC13/PD2
99 - SDMMC_1 D0/D1/D2/D3/CK/CD/CMD: PC8/PC9/PC10/PC11/PC12/PC13/PD2
135 - SDMMC_1 D0/D1/D2/D3/CK/CMD: PC8/PC9/PC10/PC11/PC12/PD2
629 usart->CMD = USART_CMD_CLEARRX; in uart_silabs_async_rx_disable()733 config->base->CMD = USART_CMD_CLEARRX | USART_CMD_CLEARTX; in uart_silabs_async_init()
120 - SDMMC D0/D1/D2/D3/CK/CMD/CD : PC8/PC9/PC10/PC11/PC12/PD2/PI8
66 - SDMMC_1 D0/D1/D2/D3/CK/CMD: PC8/PC9/PC10/PC11/PC12/PD2
2203 return NUMAKER_UTCPD_REG_WRITE_BY_NAME(dev, CMD, cmd); in numaker_tcpc_ppc_set_snk_ctrl()2218 return NUMAKER_UTCPD_REG_WRITE_BY_NAME(dev, CMD, cmd); in numaker_tcpc_ppc_set_src_ctrl()
385 | 3 | MTDO / GPIO15 | CMD |
855 * :github:`17064` - drivers/serial/uart\_ns16550: CMD\_SET\_DLF should be removed
506 * Added direct CMD to catch @ when sending data.
