Searched full:toggling (Results 1 – 25 of 27) sorted by relevance
12
15 The EXTCOMIN pin is where a square pulse for toggling VCOM will
241 * @brief Minimum time to detect connection when neither Port Partner is toggling.247 * @brief Maximum time to detect connection when neither Port Partner is toggling.253 * @brief Minimum time to detect connection when one Port Partner is toggling260 * @brief Maximum time to detect connection when one Port Partner is toggling267 * @brief Minimum time to detect connection when both Port Partners are toggling274 * @brief Maximum time to detect connection when both Port Partners are toggling
12 Time in ms for SPI SDHC to delay when toggling power to the SD card. This
50 time in ms for SDHC to delay when toggling power to the SD card. This
20 Sharp memory displays require toggling the VCOM signal periodically26 Currently the driver only supports VCOM toggling using the EXTCOMIN pin32 To use a different method of toggling for example pwm, user may not
51 shutdown mode it acts as an input and toggling it will make the sensor
25 connection is handled in hardware, for very fast coming events, toggling of
93 bool "Re-enable interrupts by toggling IER at end of ISR"
56 /* Driver will handle VCOM toggling */254 /* Start thread for toggling VCOM */ in ls0xx_init()
49 (2) tCDRP (CSn Toggling Time before Release from Deep Power-Down Mode)
102 - Power On/Off Switch. Toggling the switch to **5V0** position powers the103 board on, toggling to **GND** position powers the board off.
391 * @note The timestamp is considered valid when the timepulse pin is actively toggling.
392 * from entering debug mode when there is signal toggling on GPH5/GPH6. in ite_it8xxx2_init()
1115 Route debug GPIO toggling for the BLE Controller. Enable this when
1430 Turn on debug GPIO toggling for the BLE Controller. This is useful
1246 /* AT&T recommend toggling the KEEP_AWAKE signal to reduce missed in modem_wakeup_pin_fix()1249 LOG_DBG("Toggling MDM_KEEP_AWAKE_PIN to avoid missed characters"); in modem_wakeup_pin_fix()
244 * for End time capture and sw_switch DPPI channel toggling. in hal_sw_switch_timer_clear_ppi_config()
926 * triggered by Radio End for End time capture and sw_switch DPPI channel toggling in sw_switch()1801 * by Radio End for End time capture and sw_switch DPPI channel toggling hence in radio_tmr_end_capture()
115 | Power Switch | Power On/Off Switch. Toggling toward the Boot button powers the |116 | | board on, toggling away from Boot powers the board off. |
428 - simple toggling of GPIO for external scope tracing while minimizing extra cpu load
417 ``STACK_SIZE`` appears to be "frozen" at 0x100 when toggling ``FOO``.
800 * Power line toggling would reset SD card in imx_usdhc_get_card_present()
353 /** Value for look for connection - start DRP toggling if DRP role is set */
999 * Check that toggling lpn_set() results in correct disabled state
675 /* Avoid reflowing when toggling the focus state */
