Searched full:gpio_in (Results 1 – 11 of 11) sorted by relevance
| /Zephyr-latest/tests/drivers/pinctrl/gd32/boards/ |
| D | gd32f403z_eval.overlay | 24 <GD32_PINMUX_AFIO('C', 2, GPIO_IN, NORMP)>;
27 pinmux = <GD32_PINMUX_AFIO('A', 3, GPIO_IN, TEST_DEVICE_RMP)>,
31 pinmux = <GD32_PINMUX_AFIO('C', 5, GPIO_IN, NORMP)>;
35 pinmux = <GD32_PINMUX_AFIO('A', 6, GPIO_IN, NORMP)>;
39 pinmux = <GD32_PINMUX_AFIO('B', 7, GPIO_IN, NORMP)>;
43 pinmux = <GD32_PINMUX_AFIO('C', 8, GPIO_IN, NORMP)>;
47 pinmux = <GD32_PINMUX_AFIO('A', 9, GPIO_IN, NORMP)>;
|
| /Zephyr-latest/drivers/gpio/ |
| D | gpio_ad559x.c | 28 uint8_t gpio_in; member
49 drv_data->gpio_in, &data); in gpio_ad559x_port_get_raw()
109 data->gpio_in &= ~val; in gpio_ad559x_configure()
133 AD559X_REG_GPIO_INPUT_EN, data->gpio_in); in gpio_ad559x_configure()
135 data->gpio_in |= val; in gpio_ad559x_configure()
158 AD559X_REG_GPIO_INPUT_EN, data->gpio_in); in gpio_ad559x_configure()
|
| D | gpio_mchp_mss.c | 33 const uint32_t gpio_in; member
119 *value = gpio->gpio_in; in mss_gpio_port_get_raw()
|
| D | gpio_rpi_pico.c | 77 gpio_set_dir(pin, GPIO_IN); in gpio_rpi_configure()
|
| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | gd,gd32-pinctrl-afio.yaml | 68 applies for GPIO_IN mode.
69 - drive-open-drain: Open-drain drive mode. Only applies for GPIO_IN mode.
71 for GPIO_IN mode.
72 - bias-pull-up: Enable pull-up resistor. Only applies for GPIO_IN mode.
73 - bias-pull-down: Enable pull-down resistor. Only applies for GPIO_IN mode.
|
| D | st,stm32f1-pinctrl.yaml | 98 pinmux = <STM32F1_PINMUX('A', 9, GPIO_IN, REMAP_NO)>;
|
| /Zephyr-latest/include/zephyr/dt-bindings/pinctrl/ |
| D | stm32f1-pinctrl.h | 41 * @param mode Pin mode (ANALOG, GPIO_IN, ALTERNATE).
55 #define GPIO_IN 0x1 /* Input */ macro
|
| D | stm32-pinctrl.h | 60 * @param mode Mode (ANALOG, GPIO_IN, ALTERNATE).
|
| /Zephyr-latest/boards/enjoydigital/litex_vexriscv/ |
| D | litex_vexriscv.dts | 83 &gpio_in {
|
| /Zephyr-latest/drivers/pinctrl/ |
| D | pinctrl_stm32.c | 249 } else if (STM32_DT_PINMUX_FUNC(mux) == GPIO_IN) { in pinctrl_configure_pins()
|
| /Zephyr-latest/dts/riscv/ |
| D | riscv32-litex-vexriscv.dtsi | 249 gpio_in: gpio@e0006000 { label
|
