Home
last modified time | relevance | path

Searched +full:14 +full:us (Results 1 – 25 of 126) sorted by relevance

123456

/Zephyr-latest/dts/bindings/w1/
Dadi,max32-w1.yaml54 approximately 5us (micro second), 15us, and 7us, respectively.
58 and the time-slot recovery times out to approximately 8us, 22us, and 14us, respectively.
/Zephyr-latest/dts/bindings/input/
Dgpio-qdec.yaml19 gpios = <&gpio0 14 (GPIO_PULL_UP | GPIO_ACTIVE_HIGH)>,
23 sample-time-us = <2000>;
43 led-pre-us:
49 idle-poll-time-us are specified, can be explicitly set to 0 for no delay.
64 sample-time-us:
71 idle-poll-time-us:
77 the driver will poll every idle-poll-time-us microseconds while idle, and
/Zephyr-latest/dts/arm/ambiq/
Dambiq_apollo3_blue.dtsi42 * transition time are both lower than 1us, but considering
45 min-residency-us = <100>;
46 exit-latency-us = <5>;
53 * the software overhead 1us and deepsleep_to_run transition time
54 * is about 25us,but considering the software overhead, we set
57 min-residency-us = <2000>;
58 exit-latency-us = <125>;
109 interrupts = <14 0>;
118 interrupts = <14 0>;
127 interrupts = <14 0>;
[all …]
Dambiq_apollo3p_blue.dtsi42 * transition time are both lower than 1us, but considering
45 min-residency-us = <100>;
46 exit-latency-us = <5>;
53 * is the software overhead 1us and deepsleep_to_run transition
54 * time is about 25us,but considering the software overhead,
57 min-residency-us = <2000>;
58 exit-latency-us = <125>;
127 interrupts = <14 0>;
136 interrupts = <14 0>;
145 interrupts = <14 0>;
[all …]
/Zephyr-latest/subsys/bluetooth/controller/ll_sw/nordic/lll/
Dlll_vendor.h29 #define EVENT_OVERHEAD_START_US 428 /* 14 RTC ticks */
55 * and ticker_update. Set to 32 us, which is ~1 tick with 32768 Hz
66 * includes radio ramp up time. The value must meet hard deadline of `150 us`
73 /* Sub-microsecond conversion macros. With current timer resolution of ~30 us
74 * per tick, conversion factor is 1, and macros map 1:1 between us_frac and us.
79 #define EVENT_US_TO_US_FRAC(us) (us) argument
/Zephyr-latest/samples/drivers/jesd216/
DREADME.rst49 Byte program: type 32 + 1 * B us, max 192 + 6 * B us
50 Page program: typ 896 us, max 5376 us
69 jedec-id = [c2 28 14];
/Zephyr-latest/boards/nxp/frdm_ke17z/
Dfrdm_ke17z.dts81 gpios = <&gpioe 14 GPIO_ACTIVE_LOW>;
88 min-residency-us = <1>;
92 min-residency-us = <20000>;
93 exit-latency-us = <13>;
167 dmas = <&edma 0 14>, <&edma 1 15>;
/Zephyr-latest/drivers/led_strip/
Dtlc59731.c18 * between 1.67us and 50us. We want to go as fast as possible, but
19 * delays under 1us don't work very well, so we settle on 5us for the
21 * A pulse must be high for at least 14ns. In practice, turning a GPIO on
25 * A one is represented by an additional pulse between 275ns and 2.5us
28 * full 1us. After the pulse, we wait an additional T_CYCLE_1 to complete
44 #define TLC59731_DELAY 0x01 /* us */
45 #define TLC59731_T_CYCLE_0 0x04 /* us */
46 #define TLC59731_T_CYCLE_1 0x01 /* us */
/Zephyr-latest/boards/nxp/frdm_ke17z512/
Dfrdm_ke17z512.dts76 gpios = <&gpioe 14 GPIO_ACTIVE_LOW>;
88 min-residency-us = <1>;
92 min-residency-us = <20000>;
93 exit-latency-us = <13>;
185 dmas = <&edma 0 14>, <&edma 1 15>;
/Zephyr-latest/dts/arm/microchip/
Dmec172xnsz.dtsi36 min-residency-us = <1000000>;
42 min-residency-us = <2000000>;
65 pcrs = <4 14>;
Dmec172xnlj.dtsi36 min-residency-us = <1000000>;
42 min-residency-us = <2000000>;
65 pcrs = <4 14>;
/Zephyr-latest/.github/workflows/
Dbug_snapshot.yaml13 # Run daily at 14:05
14 - cron: '5 14 * * *'
48 aws-region: us-east-1
/Zephyr-latest/boards/silabs/dev_kits/sltb010a/
Dthunderboard.dtsi46 startup-delay-us = <100000>;
55 startup-delay-us = <100000>;
62 startup-delay-us = <100000>;
87 jedec-id = [c2 28 14];
/Zephyr-latest/boards/silabs/dev_kits/xg27_dk2602a/
Dthunderboard.dtsi46 startup-delay-us = <100000>;
55 startup-delay-us = <100000>;
62 startup-delay-us = <100000>;
87 jedec-id = [c2 28 14];
/Zephyr-latest/drivers/dma/
Ddma_pl330.h60 * TIMEOUT value of 100000us is kept to cover all possible data
61 * transfer sizes, with lesser time out value(10us) DMA channel
62 * appears to be busy on FPGA/Emul environment. Ideally 100000us
87 #define CC_DSTINC_SHIFT 14
/Zephyr-latest/dts/arm/ti/
Dcc13xx_cc26xx.dtsi34 min-residency-us = <1000>;
40 min-residency-us = <5000>;
41 exit-latency-us = <240>;
231 interrupts = <14 0>; /* interrupt #30 = 14 + 16 */
/Zephyr-latest/include/zephyr/bluetooth/
Dcs.h171 * | 14 | A1 A3 A4 A2 |
268 * Range: 1250us to 4s
296 * - 10 us
297 * - 20 us
298 * - 30 us
299 * - 40 us
300 * - 50 us
301 * - 60 us
302 * - 80 us
303 * - 145 us
[all …]
/Zephyr-latest/dts/x86/intel/
Dintel_ish5.dtsi17 min-residency-us = <500>;
24 min-residency-us = <10000>;
31 min-residency-us = <3000000>;
87 interrupts = <14 IRQ_TYPE_FIXED_LEVEL_HIGH 2>;
/Zephyr-latest/drivers/flash/
Djesd216.c228 value = 1 + ((dw11 >> 14) & 0x0F); in jesd216_bfp_decode_dw11()
253 if (php->len_dw < 14) { in jesd216_bfp_decode_dw14()
272 case 0x01: /* 1 us */ in jesd216_bfp_decode_dw14()
275 case 0x02: /* 8 us */ in jesd216_bfp_decode_dw14()
278 case 0x03: /* 64 us */ in jesd216_bfp_decode_dw14()
324 res->exit_4ba = (dw16 >> 14) & 0x3FF; in jesd216_bfp_decode_dw16()
/Zephyr-latest/doc/security/
Dsecurity-citations.rst34 BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997. [Online]. Available:
38 Available: https://msdn.microsoft.com/en-us/library/ee823878%28v=cs.20%29.aspx.
/Zephyr-latest/boards/st/st25dv_mb1283_disco/
Dst25dv_mb1283_disco.dts38 gpios = <&gpioc 14 GPIO_ACTIVE_LOW>;
156 panel-driver-settling-time-us = <1000>;
157 touch-detect-delay-us = <5000>;
/Zephyr-latest/boards/u-blox/ubx_bmd345eval/
Dubx_bmd345eval_nrf52840.dts35 gpios = <&gpio0 14 GPIO_ACTIVE_LOW>;
98 <14 0 &gpio1 10 0>, /* D8 */
102 <18 0 &gpio1 14 0>, /* D12 */
122 ctx-settle-time-us = <1>;
124 crx-settle-time-us = <1>;
/Zephyr-latest/drivers/dac/
Ddac_ad56xx.c18 * These values are actually all way less than 1us, but we can only
19 * wait with 1us precision.
202 #define DAC_AD5648_RESOLUTION 14
239 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15,
265 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15,
/Zephyr-latest/boards/renesas/ek_ra4e2/doc/
Dindex.rst23 - Native pin access through 2 x 14-pin and 1 x 40-pin male headers
161 …https://www.renesas.com/us/en/products/microcontrollers-microprocessors/ra-cortex-m-mcus/ek-ra4e2-…
164 …https://www.renesas.com/us/en/products/microcontrollers-microprocessors/ra-cortex-m-mcus/ra4e2-ent…
167 https://www.renesas.com/us/en/document/mat/ek-ra4e2-v1-users-manual
170 https://www.renesas.com/us/en/document/mah/ra4e2-group-users-manual-hardware
/Zephyr-latest/boards/renesas/ek_ra6e2/doc/
Dindex.rst21 - Native pin access through 2 x 14-pin and 1 x 40-pin male headers
161 …https://www.renesas.com/us/en/products/microcontrollers-microprocessors/ra-cortex-m-mcus/ek-ra6e2-…
164 …https://www.renesas.com/us/en/products/microcontrollers-microprocessors/ra-cortex-m-mcus/ra6e2-ent…
167 https://www.renesas.com/us/en/document/mat/ek-ra6e2-v1-users-manual
170 https://www.renesas.com/us/en/document/mah/ra6e2-group-users-manual-hardware

123456