Searched refs:speed (Results 1426 – 1450 of 1639) sorted by relevance
1...<<51525354555657585960>>...66
75 - USB OTG 2.0 full-speed, LPM and BCD177 driven by 16MHz high speed internal oscillator.
94 - USB OTG 2.0 full-speed, LPM and BCD182 driven by 16MHz high speed internal oscillator.
118 - 1 USB 2.0 full-speed crystal-less solution with LPM and BCD205 48MHz, driven by 4MHz medium speed internal oscillator.
97 - 1x USB 2.0 full-speed host and device172 240 MHz, driven by an 24 MHz high-speed external clock.
108 - USB 2.0 full-speed crystal less solution with LPM and BCD192 driven by 16MHz high speed internal oscillator.
457 maximum-speed = "full-speed";
381 maximum-speed = "full-speed";
71 current-speed = <115200>;295 current-speed = <115200>;301 These are equivalent ways to override the ``current-speed`` value in an309 current-speed = <9600>;314 current-speed = <9600>;
160 current-speed = <115200>;
159 current-speed = <115200>;
133 current-speed = <115200>;
148 current-speed = <115200>;
17 - On-board high-speed USB based debug probe with CMSIS-DAP and J-Link protocol
298 uint32_t speed; in i2c_it8xxx2_get_config() local310 speed = I2C_SPEED_SET(data->bus_freq); in i2c_it8xxx2_get_config()316 *dev_config = (I2C_MODE_CONTROLLER | speed); in i2c_it8xxx2_get_config()
678 uint32_t speed; in usb_dw_handle_enum_done() local680 speed = (base->dsts & ~USB_DWC2_DSTS_ENUMSPD_MASK) >> in usb_dw_handle_enum_done()684 speed == USB_DWC2_DSTS_ENUMSPD_LS6 ? "Low" : "Full"); in usb_dw_handle_enum_done()
49 less stack than static message creation and speed has lower priority
61 usb 2-2: new full-speed USB device number 2 using at91_ohci
30 - USB 2.0 full-speed device/host/OTG controller with on-chip PHY
145 current-speed = <115200>;
125 current-speed = <115200>;
18 - microSD card slot, with support for high-speed SDR104 mode
156 current-speed = <115200>;
483 current-speed = <115200>;510 They are not suitable for 115200 speed of UART.
495 current-speed = <115200>;522 They are not suitable for 115200 speed of UART.
220 …face/jlink.cfg -c 'transport select swd' -f target/rp2040.cfg -c "adapter speed 2000" -c 'targets …267 …face/jlink.cfg -c 'transport select swd' -f target/rp2040.cfg -c "adapter speed 2000" -c 'targets …
