Searched refs:powered (Results 1 – 25 of 110) sorted by relevance
12345
| /Zephyr-latest/boards/shields/g1120b0mipi/boards/ |
| D | mimxrt595_evk_mimxrt595s_cm33.overlay | 7 /* Change deep sleep config for suspend mode to keep SMARTDMA ram powered,
|
| /Zephyr-latest/samples/subsys/usb/common/ |
| D | Kconfig.sample_usbd | 31 bool "USB device sample Self-powered attribute"
34 Set the Self-powered attribute in the sample configuration.
|
| /Zephyr-latest/doc/services/pm/ |
| D | power_domain.rst | 10 powered by a common source to be notified of power source state changes in a
58 completely powered off to eliminate this leakage. These regions are
65 Devices external to a SoC can be powered from sources other than the main power
67 or a dedicated power IC. Multiple devices can be powered from the same source,
101 /* notify children domain is now powered */
|
| /Zephyr-latest/drivers/bbram/ |
| D | Kconfig.stm32 | 15 powered-on by VBAT when the VDD power is switched off. They are not reset
|
| /Zephyr-latest/soc/espressif/esp32c2/ |
| D | Kconfig | 22 If enabled, the MAC and baseband of Wi-Fi and Bluetooth will be powered
|
| /Zephyr-latest/soc/espressif/esp32c6/ |
| D | Kconfig | 25 If enabled, the MAC and baseband of Wi-Fi and Bluetooth will be powered
|
| /Zephyr-latest/drivers/retained_mem/ |
| D | Kconfig | 8 device is powered (may be lost in low power states).
|
| /Zephyr-latest/samples/boards/nordic/system_off/ |
| D | README.rst | 20 RAM is configured to keep the containing section powered while in system-off mode.
|
| /Zephyr-latest/drivers/sensor/st/vl53l0x/ |
| D | Kconfig | 32 value from a sensor, it is powered up and its I2C address is reconfigured
|
| /Zephyr-latest/doc/hardware/peripherals/ |
| D | retained_mem.rst | 11 powered (data may be lost in low power modes).
|
| /Zephyr-latest/subsys/usb/device/ |
| D | Kconfig | 126 bool "Set Self-powered characteristic"
129 Set Self-powered characteristic in bmAttributes to indicate
130 self powered USB device.
|
| /Zephyr-latest/soc/espressif/esp32c3/ |
| D | Kconfig | 34 If enabled, the MAC and baseband of Wi-Fi and Bluetooth will be powered
|
| /Zephyr-latest/boards/shields/pmod_acl/doc/ |
| D | index.rst | 9 The Digilent Pmod ACL is a 3-axis digital accelerometer module powered by the
|
| /Zephyr-latest/boards/shields/eval_adxl362_ardz/doc/ |
| D | index.rst | 9 The EVAL-ADXL362-ARDZ is a 3-axis digital accelerometer Arduino shield powered
|
| /Zephyr-latest/boards/shields/eval_adxl372_ardz/doc/ |
| D | index.rst | 9 The EVAL-ADXL372-ARDZ is a 3-axis digital accelerometer Arduino shield powered
|
| /Zephyr-latest/samples/boards/st/power_mgmt/wkup_pins/ |
| D | README.rst | 38 The LED will be turned off when the system is powered off.
|
| /Zephyr-latest/boards/norik/octopus_io_board/doc/ |
| D | index.rst | 69 The Octopus IO-Board can be powered from the following sources:
76 When powered from USB-C or solar cell, the board can charge the Li-Po battery. The battery voltage …
79 When powered from alkaline battery, the user needs to set switch SW1 to ALK position. This ensures …
|
| /Zephyr-latest/samples/boards/nxp/mimxrt1060_evk/system_off/ |
| D | README.rst | 40 powered back on. Alternatively, wait 10 seconds for the SNVS RTC
|
| /Zephyr-latest/drivers/mm/ |
| D | Kconfig | 26 Note that unused memory will be powered off by
|
| /Zephyr-latest/boards/phytec/reel_board/doc/ |
| D | index.rst | 20 * battery powered sensor node
332 NXP MK20DX128VFM5 SoC. The adapter is powered via a micro USB connector and
334 reel board can be flashed and debugged, powered either from battery or USB.
335 If the Adapter is powered via USB, the Adapter circuit heats the board
461 link board BASE is powered from Alternative Power Source Connector
465 link board BASE is powered from USB connector (via DCDC converter).
468 link board BASE is powered from reel board. The available power is
|
| /Zephyr-latest/drivers/auxdisplay/ |
| D | auxdisplay_itron.c | 45 bool powered; member
175 is_powered = data->powered; in auxdisplay_itron_is_powered()
|
| /Zephyr-latest/boards/beagle/beaglebone_ai64/doc/ |
| D | index.rst | 6 BeagleBone AI-64 is a computational platform powered by TI J721E SoC, which is
12 BeagleBone AI-64 is powered by TI J721E SoC, which has three domains (MAIN,
|
| /Zephyr-latest/doc/connectivity/bluetooth/api/mesh/ |
| D | core.rst | 14 The Low Power Node (LPN) role allows battery powered devices to participate in
40 the entire RPL in the persistent storage before it is powered off. Depending on
47 get powered off before the timer to store the RPL is fired. To ensure that
|
| /Zephyr-latest/samples/boards/ti/cc13x2_cc26x2/system_off/ |
| D | README.rst | 47 it had been powered back on.
|
| /Zephyr-latest/lib/mem_blocks/ |
| D | Kconfig | 19 powered down to conserve energy.
|
12345
