Home
last modified time | relevance | path

Searched refs:IEN (Results 1 – 13 of 13) sorted by relevance

/Zephyr-Core-2.7.6/drivers/counter/
Dcounter_mchp_xec.c93 counter->IEN = MCHP_BTMR_INTDIS; in counter_xec_stop()
144 counter->IEN = MCHP_BTMR_INTEN; in counter_xec_set_alarm()
165 counter->IEN = MCHP_BTMR_INTDIS; in counter_xec_cancel_alarm()
228 counter->IEN = MCHP_BTMR_INTEN; in counter_xec_set_top_value()
231 counter->IEN = MCHP_BTMR_INTDIS; in counter_xec_set_top_value()
259 counter->IEN = MCHP_BTMR_INTDIS; in counter_xec_isr()
/Zephyr-Core-2.7.6/drivers/watchdog/
Dwdt_mchp_xec.c96 wdt_regs->IEN |= MCHP_WDT_IEN_EVENT_IRQ_EN; in wdt_xec_install_timeout()
104 wdt_regs->IEN &= ~MCHP_WDT_IEN_EVENT_IRQ_EN; in wdt_xec_install_timeout()
150 wdt_regs->IEN &= ~MCHP_WDT_IEN_EVENT_IRQ_EN; in wdt_xec_isr()
/Zephyr-Core-2.7.6/soc/arm/microchip_mec/mec1501/
Dtiming.c23 B32TMR1_REGS->IEN = 0; /* Disable interrupt */ in soc_timing_init()
/Zephyr-Core-2.7.6/soc/arm/microchip_mec/mec172x/
Dtiming.c33 regs->IEN = 0; /* Disable interrupt */ in soc_timing_init()
/Zephyr-Core-2.7.6/soc/arm/microchip_mec/common/reg/
Dmec_wdt.h81 volatile uint8_t IEN; member
Dmec_timers.h80 volatile uint8_t IEN; member
/Zephyr-Core-2.7.6/drivers/spi/
Dspi_xec_qmspi.c258 regs->IEN = 0; in qmspi_tx_dummy_clocks()
407 regs->IEN = 0; in qmspi_tx()
477 regs->IEN = 0; in qmspi_rx()
/Zephyr-Core-2.7.6/drivers/gpio/
Dgpio_gecko.c199 if ((GPIO->IEN & BIT(pin)) != 0) { in gpio_gecko_pin_interrupt_configure()
/Zephyr-Core-2.7.6/soc/arm/microchip_mec/mec172x/reg/
Dmec172x_qspi.h406 volatile uint32_t IEN; member
/Zephyr-Core-2.7.6/drivers/serial/
Dleuart_gecko.c193 return (base->IEN & mask) in leuart_gecko_irq_rx_ready()
Duart_gecko.c236 return (config->base->IEN & mask) in uart_gecko_irq_rx_ready()
/Zephyr-Core-2.7.6/drivers/espi/
Despi_mchp_xec.c790 ESPI_FC_REGS->IEN |= MCHP_ESPI_FC_IEN_CHG_EN; in espi_init_flash()
791 ESPI_FC_REGS->IEN |= MCHP_ESPI_FC_IEN_DONE; in espi_init_flash()
Despi_saf_mchp_xec.c240 regs->IEN = MCHP_QMSPI_IEN_XFR_DONE; in saf_qmspi_init()