Searched full:ultra (Results 1 – 25 of 140) sorted by relevance
123456
| /Zephyr-latest/boards/nxp/rd_rw612_bga/ |
| D | rd_rw612_bga-pinctrl.dtsi | 30 slew-rate = "ultra";
60 slew-rate = "ultra";
72 slew-rate = "ultra";
77 slew-rate = "ultra";
|
| /Zephyr-latest/boards/shields/boostxl_ulpsense/doc/ |
| D | index.rst | 3 BOOSTXL-ULPSENSE: Ultra-low Power Sensor BoosterPack
9 The Ultra-low Power Sensor BoosterPack (BOOSTXL-ULPSENSE) adds analog and
12 buttons, a light sensor, a reed switch, and an ultra-low power accelerometer.
|
| /Zephyr-latest/include/zephyr/dt-bindings/sensor/ |
| D | lis2du12.h | 17 #define LIS2DU12_DT_ODR_AT_1Hz6_ULP 0x01 /* 1Hz6 (ultra low power) */
18 #define LIS2DU12_DT_ODR_AT_3Hz_ULP 0x02 /* 3Hz (ultra low power) */
19 #define LIS2DU12_DT_ODR_AT_6Hz_ULP 0x03 /* 6Hz (ultra low power) */
|
| D | lis2dux12.h | 19 #define LIS2DUX12_DT_ODR_1Hz_ULP 1 /* available in ultra-low power mode */
20 #define LIS2DUX12_DT_ODR_3Hz_ULP 2 /* available in ultra-low power mode */
21 #define LIS2DUX12_DT_ODR_25Hz_ULP 3 /* available in ultra-low power mode */
|
| /Zephyr-latest/dts/bindings/sensor/ |
| D | bosch,bmp180.yaml | 18 0 ultra low power, 1 sample
21 3 ultra high, 8 sample
|
| D | invensense,icp10125.yaml | 19 - "ultra-low-noise"
29 - "ultra-low-noise"
|
| D | st,lis2de12-i2c.yaml | 5 STMicroelectronics LIS2DE12 3-axis ultra-low power accelerometer sensor
|
| D | st,lis2de12-spi.yaml | 5 STMicroelectronics LIS2DE12 3-axis ultra-low power accelerometer sensor
|
| D | st,lis2du12-i2c.yaml | 5 STMicroelectronics LIS2DU12 3-axis ultra-low power accelerometer sensor
|
| D | st,lis2du12-spi.yaml | 5 STMicroelectronics LIS2DU12 3-axis ultra-low power accelerometer sensor
|
| /Zephyr-latest/dts/bindings/mtd/ |
| D | atmel,at45.yaml | 61 When set, the driver will use the Ultra-Deep Power-Down command instead
65 SRAM buffers in the chip, the difference between the Deep and Ultra-Deep
74 mode (or Ultra-Deep Power-Down mode when the "use-udpd" property is set)
82 mode (or Ultra-Deep Power-Down mode when the "use-udpd" property is set)
|
| D | jedec,spi-nor-common.yaml | 99 Select to configure flash to use ultra low power mode or high
101 faster write and erase performance, but use more power than ultra
104 Only supported on Macronix MX25R Ultra Low Power series.
|
| /Zephyr-latest/boards/atmel/sam/sam_v71_xult/ |
| D | board.yml | 3 full_name: SAM V71(B) Xplained Ultra
|
| D | sam_v71_xult_samv71q21.yaml | 2 name: SAM V71 Xplained Ultra
|
| D | sam_v71_xult_samv71q21b.yaml | 2 name: SAM V71 Xplained Ultra (Revision B)
|
| D | sam_v71_xult_samv71q21.dts | 15 model = "Atmel SAM V71 Xplained Ultra board";
|
| D | sam_v71_xult_samv71q21b.dts | 14 model = "Atmel SAM V71B Xplained Ultra board";
|
| /Zephyr-latest/drivers/input/ |
| D | Kconfig.paw32xx | 5 bool "PAW32xx ultra low power wireless mouse chip"
|
| /Zephyr-latest/boards/st/stm32wb5mmg/ |
| D | stm32wb5mmg.yaml | 2 name: ST STM32WB5MMG Ultra-low-power Module
|
| /Zephyr-latest/boards/silabs/radio_boards/ |
| D | index.rst | 44 - Ultra-low power 128x128 pixel memory LCD
56 - Ultra-low power 128x128 pixel memory LCD
|
| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | nxp,mci-io-mux.yaml | 62 - "ultra"
69 3 - fastest slew rate (ultra)
|
| /Zephyr-latest/subsys/sd/ |
| D | Kconfig | 97 bool "Ultra high speed SD card protocol support"
100 Enable support for ultra high speed SD cards. This can be disabled to
|
| /Zephyr-latest/boards/snps/iotdk/ |
| D | Kconfig.iotdk | 13 ultra-low power process, and a rich set of peripherals commonly used in IoT designs
|
| /Zephyr-latest/samples/boards/st/steval_stwinbx1/sensors/ |
| D | README.rst | 18 - IIS2DLPC: high-performance ultra-low-power 3-axis accelerometer for industrial applications
20 - ILPS22QS: ultra-compact piezoresistive absolute pressure sensor
|
| /Zephyr-latest/drivers/adc/ |
| D | Kconfig.tla202x | 13 TLA202x Cost-Optimized, Ultra-Small, 12-Bit, System-Monitoring ADCs
|
123456
