Home
last modified time | relevance | path

Searched full:multiplied (Results 1 – 25 of 36) sorted by relevance

12

/Zephyr-latest/subsys/net/lib/ptp/
Dddt.h26 * @note 5.3.2 - time interval expressed in nanoseconds multiplied by 2^16
122 * It's a dimensionless fraction and multiplied by 2^62.
Dmsg.h70 /** Value of correction in nanoseconds multiplied by 2^16. */
/Zephyr-latest/subsys/mgmt/osdp/
DKconfig.cp27 the queue size is multiplied by number of connected PD so this can grow
DKconfig.pd21 the queue size is multiplied by number of connected PD so this can grow
/Zephyr-latest/subsys/bluetooth/controller/ll_sw/
Dull_df_types.h26 * is multiplied by 2):
/Zephyr-latest/samples/sensor/amg88xx/
DREADME.rst24 Sample shows values in |deg| C multiplied by 100.
/Zephyr-latest/samples/drivers/counter/alarm/
DREADME.rst11 expiry, a new alarm is configured with a delay multiplied by 2.
/Zephyr-latest/drivers/serial/
Duart_opentitan.c102 * calculated based on baud ticks per system clock tick multiplied by a
/Zephyr-latest/drivers/sensor/ltrf216a/
Dltrf216a.c127 * 0.45 -> 45 / 100, multiplied by 1000000 for millilux in ltrf216a_channel_get()
/Zephyr-latest/drivers/sensor/maxim/max44009/
Dmax44009.c161 /* lux is the integer of sample output multiplied by 0.045. */ in max44009_channel_get()
/Zephyr-latest/drivers/flash/
Dsoc_flash_nrf.h32 /* The timeout is multiplied by CONFIG_SOC_FLASH_NRF_TIMEOUT_MULTIPLIER/10
/Zephyr-latest/dts/bindings/memory-controllers/
Datmel,sam-smc.yaml148 is encoded in 9 bits where the two highest bits are multiplied
/Zephyr-latest/drivers/sensor/vishay/vcnl36825t/
Dvcnl36825t.c249 * @param meas_factor factor which needs to be multiplied to cope with additional delays (multiplied
/Zephyr-latest/soc/nordic/nrf54l/
Dsoc.c84 * values multiplied by 2^9, e.g. 0.765625 * 2^9 = 392. in nordicsemi_nrf54l_init()
/Zephyr-latest/include/zephyr/usb_c/
Dtcpci.h704 * Value read from register must be multiplied by this value to get a real voltage in mV.
718 * Value read from register must be multiplied by this value to get a real voltage in mV.
732 * Value read from register must be multiplied by this value to get a real voltage in mV.
744 * Value read from register must be multiplied by this value to get a real voltage in mV.
761 * Value read from register must be multiplied by this value to get a real voltage in mV.
/Zephyr-latest/include/zephyr/dsp/
Dbasicmath.h279 * These are multiplied to yield a 2.14 intermediate result and this is shifted with saturation to
296 * These are multiplied to yield a 2.30 intermediate result and this is shifted with saturation to
313 * These are multiplied to yield a 2.62 intermediate result and this is shifted with saturation to
402 * Computes the dot product of two vectors. The vectors are multiplied element-by-element and then
/Zephyr-latest/drivers/fuel_gauge/max17048/
Dmax17048.c135 * To avoid floats, the value will be multiplied by 208 instead of 0.208, taking into in max17048_crate()
/Zephyr-latest/include/zephyr/sys/
Dtimeutil.h161 * A duration in observed local clock ticks must be multiplied by
/Zephyr-latest/drivers/pwm/
Dpwm_mchp_xec.c34 * Multiplied by the highest divider: 16
/Zephyr-latest/doc/hardware/peripherals/can/
Dcontroller.rst44 multiplied by the time of single time quantum.
/Zephyr-latest/doc/services/ipc/ipc_service/backends/
Dipc_service_icbmsg.rst135 …* ICMsg message size for 4 bytes of content (refer to the ICMsg specification) multiplied by ``loc…
/Zephyr-latest/subsys/net/l2/ieee802154/
Dieee802154_utils.h339 * @param multiplier The factor by which the symbol period is to be multiplied.
/Zephyr-latest/dts/bindings/ethernet/
Dsnps,dwcxgmac.yaml144 When this is set to true, the PBL value is multiplied eight times.
/Zephyr-latest/drivers/sensor/st/lis2dh/
Dlis2dh.c24 * multiplied by 100.
/Zephyr-latest/soc/nxp/imxrt/imxrt5xx/cm33/
Dsoc.c483 * fixed multiplied of 18, and use this output frequency for the DPHY. in imxrt_pre_init_display_interface()

12