Searched full:dnoe (Results 1 – 3 of 3) sorted by relevance
9 Schematic using dual-supply bus transceiver and separate dout and dnoe pins44 dnoe-gpios -------|dir gnd|-----+80 dnoe-gpios:
45 struct gpio_dt_spec dnoe; member183 if (config->dnoe.port) { in pin_swdio_out_enable()185 swdp_ll_pin_set(config->dnoe_reg, config->dnoe.pin); in pin_swdio_out_enable()187 gpio_pin_set_dt(&config->dnoe, 1); in pin_swdio_out_enable()205 if (config->dnoe.port) { in pin_swdio_out_disable()207 swdp_ll_pin_clr(config->dnoe_reg, config->dnoe.pin); in pin_swdio_out_disable()209 gpio_pin_set_dt(&config->dnoe, 0); in pin_swdio_out_disable()573 if (config->dnoe.port) { in sw_port_on()574 ret = gpio_pin_configure_dt(&config->dnoe, GPIO_OUTPUT_ACTIVE); in sw_port_on()620 if (config->dnoe.port) { in sw_port_off()[all …]
14 dnoe-gpios = <&arduino_header 12 GPIO_ACTIVE_HIGH>; /* D6 */
