Home
last modified time | relevance | path

Searched full:spread (Results 1 – 19 of 19) sorted by relevance

/Zephyr-latest/drivers/ethernet/
DKconfig.cyclonev31 Received packets are spread across the required number of fragment
DKconfig.dwmac59 Received packets are spread across the required number of fragment
/Zephyr-latest/lib/hash/
DKconfig.hash_map26 use tends to incur more cache-misses as nodes are spread throughout
/Zephyr-latest/dts/bindings/stepper/adi/
Dadi,trinamic-gconf.yaml10 A high level on the pin SPREAD inverts this flag to switch between both chopper modes.
/Zephyr-latest/include/zephyr/drivers/serial/
Duart_async_rx.h40 /* Total amount of pending bytes. Bytes may be spread across multiple RX buffers. */
147 * that was directly used by the UART driver. Since received data is spread across
/Zephyr-latest/doc/connectivity/lora_lorawan/
Dindex.rst13 LoRa acts as the physical layer (PHY) based on the chirp spread spectrum
/Zephyr-latest/soc/nxp/imxrt/imxrt118x/
Dsoc.c64 /* Spread spectrum parameter */
66 /* Enable spread spectrum or not */
71 /* Denominator of spread spectrum */
73 /* Spread spectrum parameter */
75 /* Enable spread spectrum or not */
/Zephyr-latest/arch/arm64/core/
Dearly_mem_funcs.S33 /* spread the byte value across whole 64 bits */
/Zephyr-latest/soc/nxp/imxrt/imxrt11xx/
Dsoc.c85 /* Denominator of spread spectrum */
87 /* Spread spectrum parameter */
89 /* Enable spread spectrum or not */
115 /* Spread spectrum parameter */
117 /* Enable spread spectrum or not */
/Zephyr-latest/subsys/bluetooth/controller/ll_sw/openisa/hal/RV32M1/
Ddebug.h76 * GPIO routed to the headers. Unfortunately they are spread across
/Zephyr-latest/arch/arc/core/
Disr_wrapper.S44 The context switch code is spread in these files:
/Zephyr-latest/soc/mediatek/mt8xxx/
Dmtk_adsp_load.py105 # These have registers spread across two blocks
/Zephyr-latest/doc/connectivity/bluetooth/api/mesh/
Daccess.rst19 power outlet would spread this functionality across four elements, with each
Ddfu.rst73 All DFU models instantiate one or more :ref:`bluetooth_mesh_blob`, and may need to be spread over
/Zephyr-latest/drivers/sensor/
Ddefault_rtio_sensor.c221 * Spread the q31 values. This is needed because some channels are 3D. If in sensor_submit_fallback_sync()
/Zephyr-latest/subsys/usb/device/class/hid/
Dcore.c342 /* Delay it once until it has spread. */ in hid_sof_handler()
/Zephyr-latest/drivers/lora/
Drylrxxx.c281 LOG_ERR("datarate/spread factor must be between 7 and 12 inclusive"); in rylr_set_rf_parameters()
/Zephyr-latest/doc/kernel/usermode/
Dmemory_domain.rst229 objects spread out across several C files into a single partition.
/Zephyr-latest/scripts/
Dspelling.txt1466 spreaded||spread