Home
last modified time | relevance | path

Searched full:both (Results 1 – 25 of 1409) sorted by relevance

12345678910>>...57

/Zephyr-latest/tests/bsim/bluetooth/mesh/tests_scripts/priv_beacon/
Dpriv_proxy_gatt.sh10 # 0. Both TX and RX device disables SNB and GATT proxy, and enables
11 # Private GATT proxy. Test mode for IV update is also enabled on both devices.
14 # 2. Both TX and RX device disables the scanner to prevent interferance
17 # 4. Both TX and RX device verifies that the IV index has been updated.
/Zephyr-latest/tests/bsim/bluetooth/mesh/tests_scripts/op_agg/
Dmodel_coex.sh10 # Aggregator server model. The test verifies that both the incoming and outgoing
14 # 1. Both Tester and DUT device initialize both Opcode aggregator server and client.
15 # Both devices starts an Opcode aggregator sequence and populates the buffer.
/Zephyr-latest/boards/native/nrf_bsim/
DKconfig13 It needs the BabbleSim simulator both in compile time and to execute
24 It needs the BabbleSim simulator both in compile time and to execute
35 It needs the BabbleSim simulator both in compile time and to execute
46 It needs the BabbleSim simulator both in compile time and to execute
/Zephyr-latest/tests/arch/x86/direct_isr/src/
Ddirect_isr.c80 "Both ISR should not execute"); in ZTEST()
92 "Both ISR should execute"); in ZTEST()
102 "Both ISR should not execute again"); in ZTEST()
109 "Both ISR should execute again(%d)(%d)", in ZTEST()
118 "Both ISR should execute again(%d)(%d)", in ZTEST()
/Zephyr-latest/dts/bindings/gpio/
Dxlnx,ps-gpio.yaml9 This GPIO controller is contained in both the Xilinx Zynq-7000 and
10 ZynqMP (UltraScale) SoCs. It interfaces both I/O pins of the SoC,
32 The controller is interrupt-capable. Certain pins both in the Zynq-
/Zephyr-latest/tests/bsim/bluetooth/host/misc/sample_test/src/
Ddata.h15 /* Both payloads are assumed to be the same size in order to simplify the test
19 "Both payloads should be of equal length");
/Zephyr-latest/dts/bindings/memory-controllers/
Dst,stm32-fmc-sdram.yaml15 bank 2 (@1) or both. You can enable the FMC SDRAM controller in your board
134 - SDCLK: SDRAM clock period. If two SDRAM devices are used both should
136 - RBURST: Enable burst read mode. If two SDRAM devices are used both
139 latency. If two SDRAM devices are used both should have the same
159 device in both banks.
164 programmed with the timing of the slowest device in both banks.
/Zephyr-latest/subsys/mgmt/updatehub/
DKconfig127 simultaneously, enable "Both download and flash verifications"
139 enable "Both download and flash verifications" option.
142 bool "SHA-256 from both download and flash"
144 Enables SHA-256 verification on both data stream while downloading
/Zephyr-latest/tests/kernel/interrupt/src/
Dregular_isr.c80 "Both ISR should execute"); in ZTEST()
90 "Both ISR should not execute again(%d)(%d)", in ZTEST()
113 "Both ISR should execute again(%d)(%d)", in ZTEST()
122 "Both ISR should execute again(%d)(%d)", in ZTEST()
/Zephyr-latest/samples/userspace/syscall_perf/
DREADME.rst18 Then both threads call :c:func:`k_current_get()` which returns a reference to the
21 Both threads are showing the number of core clock cycles and the number of
/Zephyr-latest/dts/bindings/ipc/
Dzephyr,ipc-icmsg.yaml29 invalidation or the write-back size for both sides of the communication.
35 dcache-alignment = <32>; for both
/Zephyr-latest/samples/net/prometheus/src/
Dcertificate.h13 /** Used for both the public and private server keys */
15 /** Used for both the public and private client keys */
/Zephyr-latest/samples/application_development/external_lib/
DREADME.rst11 The demonstrates both how to build the external library using a different build
35 https://gnuwin32.sourceforge.net/packages/make.htm by either getting both the
/Zephyr-latest/tests/bsim/bluetooth/mesh/tests_scripts/friendship/
Dmsg_va_collision.sh13 # 2.1. Friend sends a message to each virtual address, LPN receives both messages.
17 # 3.2. Friend sends a message to each virtual address. LPN receives both, but successfully decrypts
/Zephyr-latest/tests/drivers/gpio/gpio_basic_api/src/
Dtest_config_trigger.c42 /* 2. Enable PIN callback as both edges */ in ZTEST()
45 TC_PRINT("Both edge GPIO interrupt not supported.\n"); in ZTEST()
93 /* 2. Enable PIN callback as both edges */ in ZTEST()
96 TC_PRINT("Both edge GPIO interrupt not supported.\n"); in ZTEST()
/Zephyr-latest/samples/sensor/th02/
DREADME.rst17 This sample uses the TH02 sensor and the grove LCD display. Both devices are
28 The easiest way to get this wired is to use the Grove shield and connect both
/Zephyr-latest/samples/drivers/i2c/rtio_loopback/
DREADME.rst20 I2C peripheral role, both connected to the same I2C bus.
21 * An I2C controller supporting both I2C controller and peripheral role
/Zephyr-latest/dts/common/nordic/
Dnrf5340_shared_sram_partition.dtsi10 * This file, or a board specific variant of it, must be included by both
11 * cpuapp and cpunet application to ensure both processors have the same
/Zephyr-latest/doc/_extensions/zephyr/
Dhtml_redirects.py59 # after both reading and writing, this extension is safe for both.
81 "Check that both the source and destination are complete docnames."
/Zephyr-latest/doc/services/portability/posix/implementation/
Dindex.rst32 elsewhere, unless required both by the POSIX API implementation and some other feature. An
37 - When the POSIX API and another Zephyr subsystem both rely on a feature, the implementation of
38 that feature should be as a separate Zephyr library that can be used by both the POSIX API and
/Zephyr-latest/boards/
Dindex.rst23 both a vendor and an architecture, only boards that match both will be displayed. Within a
/Zephyr-latest/doc/connectivity/networking/api/
Dtraffic-class.rst12 to classify both received and sent network packets. See more information about
23 kernel work queue. The maximum number of traffic classes for both Rx and Tx
/Zephyr-latest/include/zephyr/linker/
Dapp_smem.ld10 * So if doing it normally, both files are being included
20 * Since the dependency list of A.cmd contains both
Dapp_smem_pinned.ld14 * So if doing it normally, both files are being included
24 * Since the dependency list of A.cmd contains both
/Zephyr-latest/tests/drivers/i2c/i2c_target_api/
DREADME.txt15 This test was originally designed for I2C controllers that support both
26 CONFIG_APP_DUAL_ROLE_I2C is selected, register both.

12345678910>>...57