Searched full:applies (Results 1 – 25 of 165) sorted by relevance
1234567
| /Zephyr-latest/dts/bindings/reserved-memory/ |
| D | nordic,owned-memory.yaml | 68 Deprecated, applies only if 'nordic,access' is not defined.
79 Deprecated, applies only if 'nordic,access' is not defined.
86 Deprecated, applies only if 'nordic,access' is not defined.
93 Deprecated, applies only if 'nordic,access' is not defined.
100 Deprecated, applies only if 'nordic,access' is not defined.
107 Deprecated, applies only if 'nordic,access' is not defined.
|
| /Zephyr-latest/dts/bindings/qspi/ |
| D | nxp,s32-qspi.yaml | 130 This property applies to side A of the controller.
137 This property applies to side A of the controller.
148 This property applies to side A of the controller.
154 This property applies to side A of the controller.
164 This property applies to side A of the controller.
174 This property applies to side A of the controller.
184 This property applies to side A of the controller.
194 This property applies to side A of the controller.
203 This property applies to side A of the controller.
|
| /Zephyr-latest/soc/nxp/imx/imx6sx/ |
| D | soc_clk_freq.h | 19 * @brief Get clock frequency applies to the PWM module
22 * @return clock frequency (in HZ) applies to the PWM module
|
| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | gd,gd32-pinctrl-afio.yaml | 68 applies for GPIO_IN mode.
69 - drive-open-drain: Open-drain drive mode. Only applies for GPIO_IN mode.
70 - bias-disable: Disable pull-up/down (default, not required). Only applies
72 - bias-pull-up: Enable pull-up resistor. Only applies for GPIO_IN mode.
73 - bias-pull-down: Enable pull-down resistor. Only applies for GPIO_IN mode.
75 signal (default: 2MHz). Only applies for ALTERNATE mode.
|
| /Zephyr-latest/include/zephyr/dt-bindings/regulator/ |
| D | npm2100.h | 20 /* Load switch selection, applies to LDOSW only */
23 /* DPS modes applies to BOOST only */
|
| /Zephyr-latest/soc/nxp/imx/imx7d/ |
| D | soc_clk_freq.h | 19 * @brief Get clock frequency applies to the PWM module
22 * @return clock frequency (in HZ) applies to the PWM module
|
| /Zephyr-latest/tests/bsim/bluetooth/host/misc/hfc_multilink/tester/ |
| D | prj.conf | 15 # FIXME: check if this still applies
|
| /Zephyr-latest/include/zephyr/drivers/serial/ |
| D | uart_ns16550.h | 19 * @note This only applies to Synopsys Designware UART IP block.
|
| /Zephyr-latest/tests/drivers/clock_control/stm32_clock_configuration/stm32_common_core/boards/ |
| D | msi_range11.overlay | 9 * It is assumed that applies after clear all clocks with .overlay file.
|
| D | wl_32_hse.overlay | 10 * It applies to the stm32wl where the hse prescaler is 1 and by-passed
|
| D | pll_48_msi_4.overlay | 10 * It applies to the stm32xx where the msi is 4MHz
|
| D | wb_pll_48_hsi_16.overlay | 10 * It applies to the stm32wb
|
| D | wb_pll_48_msi_4.overlay | 10 * It applies to the stm32wb where the msi is 4MHz
|
| D | wb_pll_64_hse_32.overlay | 10 * It applies to the stm32wb
|
| D | wl_pll_48_hse_32.overlay | 10 * It applies to the stm32wl where the hse prescaler is 2 and by-passed
|
| /Zephyr-latest/dts/bindings/can/ |
| D | zephyr,native-linux-can.yaml | 17 option. Note that it applies for every instance of this driver.
|
| /Zephyr-latest/soc/nordic/nrf52/ |
| D | Kconfig | 101 This anomaly applies to IC revisions "Engineering B" up to "3", the most
113 This anomaly applies to IC revisions up to "3", the most recent one.
|
| /Zephyr-latest/doc/build/snippets/ |
| D | index.rst | 8 configuration separately when it applies to multiple different applications.
|
| /Zephyr-latest/dts/bindings/sensor/ |
| D | adi,adxl362.yaml | 29 Only applies for Linked and Loop mode, ignored otherwise.
|
| /Zephyr-latest/subsys/usb/usb_c/ |
| D | usbc_tc_snk_states_internal.h | 31 * @brief Super state that applies Rd
|
| /Zephyr-latest/subsys/net/lib/tls_credentials/ |
| D | Kconfig.shell | 25 output should be. Must be a multiple of 4. Applies only to ??? mode.
|
| /Zephyr-latest/doc/project/ |
| D | communication.rst | 18 the mailing list. The same applies to code reviews.
|
| /Zephyr-latest/dts/bindings/spi/ |
| D | nxp,lpc-spi.yaml | 40 Applies to SPI master and slave configurations.
|
| /Zephyr-latest/drivers/display/ |
| D | Kconfig.sdl | 60 This applies when the pixel format is MONO01/MONO10.
|
| /Zephyr-latest/include/zephyr/drivers/led/ |
| D | is31fl3733.h | 26 * from per-led brightness, and applies to all LEDs.
|
1234567
