Searched full:additionally (Results 1 – 25 of 179) sorted by relevance
12345678
| /Zephyr-latest/doc/connectivity/canbus/ |
| D | isotp.rst | 22 Additionally, it adds a flow control mechanism to influence the sender's
32 the entire payload data and additionally, the first few bytes of payload data.
|
| /Zephyr-latest/samples/drivers/ipm/ipm_ivshmem/boards/ |
| D | qemu_cortex_a53.conf | 15 # Additionally, our test also uses malloc
|
| /Zephyr-latest/samples/drivers/virtualization/ivshmem/doorbell/boards/ |
| D | qemu_cortex_a53.conf | 15 # Additionally, our test also uses malloc
|
| D | qemu_kvm_arm64.conf | 15 # Additionally, our test also uses malloc
|
| /Zephyr-latest/modules/trusted-firmware-a/ |
| D | Kconfig | 11 additionally generate a TF-A image for the Secure Execution
|
| /Zephyr-latest/doc/hardware/peripherals/ |
| D | haptics.rst | 19 Additionally, haptic driver devices often offer controls for adjusting and
|
| D | gnss.rst | 14 additionally provide a precise time synchronization mechanism,
|
| /Zephyr-latest/dts/bindings/power-domain/ |
| D | power-domain-gpio-monitor.yaml | 10 child nodes. Additionally, due to the asynchronous nature of monitoring, a
|
| /Zephyr-latest/dts/bindings/sensor/ |
| D | st,vl53l1x.yaml | 16 VDD is not present). Additionally, if XSHUT is connected
|
| D | sensirion,shtcx.yaml | 7 Additionally use "sensirion,shtc1" or "sensirion,shtc3" compatibles
|
| /Zephyr-latest/tests/modules/thrift/ThriftTest/ |
| D | overlay-tls.conf | 6 # Additionally, upstream Apache Thrift uses socketpair for cancellation rather
|
| /Zephyr-latest/samples/drivers/charger/ |
| D | README.rst | 22 the battery pack. Additionally, the sample intentionally does not respond to the reported charger
|
| /Zephyr-latest/doc/develop/sca/ |
| D | sparse.rst | 11 address spaces do not get confused. Additionally it supports a ``force``
|
| /Zephyr-latest/soc/nxp/lpc/lpc54xxx/ |
| D | Kconfig | 44 This is the address the second core will boot from. Additionally this
|
| /Zephyr-latest/samples/bluetooth/direct_adv/ |
| D | README.rst | 12 boot direct advertising to the bonded central will be performed. Additionally this sample
|
| /Zephyr-latest/include/zephyr/ |
| D | irq_offload.h | 28 * Additionally, when CONFIG_IRQ_OFFLOAD_NESTED is set by the
|
| /Zephyr-latest/soc/nordic/nrf92/ |
| D | Kconfig.soc | 9 # Additionally, the nRF9230 contains several CPUs, similarly
|
| /Zephyr-latest/samples/basic/hash_map/ |
| D | README.rst | 30 Additionally, it is possible to use one of the other Hashmap implementations by specifying
|
| /Zephyr-latest/samples/bluetooth/peripheral_accept_list/ |
| D | README.rst | 13 accepted if the central device is on the accept list. Additionally, scan response
|
| /Zephyr-latest/lib/posix/options/ |
| D | Kconfig.profile | 73 PSE51. Additionally, it includes interfaces for file descriptor management, filesystem
89 PSE52. Additionally, it includes interfaces for POSIX multi-processing, networking, pipes,
|
| /Zephyr-latest/samples/posix/uname/ |
| D | README.rst | 10 it is output to the console. Additionally, uname is added as a shell command and system information
|
| /Zephyr-latest/samples/boards/nxp/mimxrt1060_evk/system_off/ |
| D | README.rst | 15 additionally set an alarm 10 seconds in the future to wake up the processor
|
| /Zephyr-latest/doc/services/serialization/ |
| D | nanopb.rst | 42 Additionally, Nanopb is an optional module and needs to be added explicitly to the workspace:
|
| /Zephyr-latest/samples/boards/nordic/nrfx/ |
| D | README.rst | 13 so that the nrfx_gpiote driver can use it. Additionally, it shows
|
| /Zephyr-latest/tests/subsys/portability/cmsis_rtos_v1/src/ |
| D | kernel_apis.c | 20 * Additionally, if RC is used for low frequency clock then it has 5% tolerance.
|
12345678
