| /Linux-v4.19/Documentation/devicetree/bindings/clock/ |
| D | uniphier-clock.txt | 84 10: USB2 ch2 host
87 14: USB2 ch2 PHY
124 2: UART ch2
128 6: I2C ch2
|
| /Linux-v4.19/drivers/input/touchscreen/ |
| D | mxs-lradc-ts.c | 170 unsigned int ch1, unsigned int ch2) in mxs_lradc_setup_ts_pressure() argument
185 writel(reg, ts->base + LRADC_CH(ch2)); in mxs_lradc_setup_ts_pressure()
194 ts->base + LRADC_CH(ch2) + STMP_OFFSET_REG_CLR); in mxs_lradc_setup_ts_pressure()
197 writel(LRADC_DELAY_TRIGGER(1 << ch1) | LRADC_DELAY_TRIGGER(1 << ch2) | in mxs_lradc_setup_ts_pressure()
203 writel(LRADC_CTRL1_LRADC_IRQ(ch2), in mxs_lradc_setup_ts_pressure()
234 unsigned int ch1, unsigned int ch2) in mxs_lradc_read_ts_pressure() argument
239 mask = LRADC_CTRL1_LRADC_IRQ(ch1) | LRADC_CTRL1_LRADC_IRQ(ch2); in mxs_lradc_read_ts_pressure()
248 m2 = mxs_lradc_ts_read_raw_channel(ts, ch2); in mxs_lradc_read_ts_pressure()
|
| /Linux-v4.19/sound/pci/ice1712/ |
| D | se.c | 38 unsigned char ch1, ch2; member
465 uc->value.integer.value[1] = spec->vol[n].ch2; in se200pci_cont_volume_get()
497 spec->vol[n].ch2); in se200pci_cont_update()
503 spec->vol[n].ch2); in se200pci_cont_update()
509 spec->vol[n].ch2); in se200pci_cont_update()
546 if (spec->vol[n].ch2 != vol2) { in se200pci_cont_volume_put()
547 spec->vol[n].ch2 = vol2; in se200pci_cont_volume_put()
|
| D | wm8766.h | 139 void (*set)(struct snd_wm8766 *wm, u16 ch1, u16 ch2);
140 void (*get)(struct snd_wm8766 *wm, u16 *ch1, u16 *ch2);
|
| D | wm8776.h | 195 void (*set)(struct snd_wm8776 *wm, u16 ch1, u16 ch2);
196 void (*get)(struct snd_wm8776 *wm, u16 *ch1, u16 *ch2);
|
| /Linux-v4.19/drivers/gpu/drm/i915/ |
| D | dvo_tfp410.c | 158 u8 ch1, ch2; in tfp410_getid() local
161 tfp410_readb(dvo, addr+1, &ch2)) in tfp410_getid()
162 return ((ch2 << 8) & 0xFF00) | (ch1 & 0x00FF); in tfp410_getid()
|
| /Linux-v4.19/sound/soc/amd/ |
| D | acp-pcm-dma.c | 351 ch_acp_i2s = rtd->ch2; in config_acp_dma()
354 ch_acp_sysmem = rtd->ch2; in config_acp_dma()
904 rtd->ch2 = ACP_TO_I2S_DMA_BT_INSTANCE_CH_NUM; in acp_dma_hw_params()
925 rtd->ch2 = ACP_TO_I2S_DMA_CH_NUM; in acp_dma_hw_params()
941 rtd->ch2 = ACP_TO_SYSRAM_BT_INSTANCE_CH_NUM; in acp_dma_hw_params()
957 rtd->ch2 = ACP_TO_SYSRAM_CH_NUM; in acp_dma_hw_params()
1076 ch_acp_i2s = rtd->ch2; in acp_dma_prepare()
1079 ch_acp_sysmem = rtd->ch2; in acp_dma_prepare()
1122 acp_dma_start(rtd->acp_mmio, rtd->ch2, true); in acp_dma_trigger()
1129 acp_dma_stop(rtd->acp_mmio, rtd->ch2); in acp_dma_trigger()
|
| D | acp.h | 133 u16 ch2; member
|
| /Linux-v4.19/Documentation/devicetree/bindings/mfd/ |
| D | stm32-timers.txt | 25 names are: "ch1", "ch2", "ch3", "ch4", "up", "trig",
63 dma-names = "ch1", "ch2", "ch3", "ch4", "up", "trig", "com";
|
| /Linux-v4.19/arch/arm/boot/dts/ |
| D | stih418-clock.dtsi | 110 "clk-s-c0-fs0-ch2",
217 "clk-s-d0-fs0-ch2",
253 "clk-s-d2-fs0-ch2",
308 "clk-s-d3-fs0-ch2",
|
| D | stih407-clock.dtsi | 110 "clk-s-c0-fs0-ch2",
215 "clk-s-d0-fs0-ch2",
249 "clk-s-d2-fs0-ch2",
297 "clk-s-d3-fs0-ch2",
|
| D | stih410-clock.dtsi | 111 "clk-s-c0-fs0-ch2",
223 "clk-s-d0-fs0-ch2",
259 "clk-s-d2-fs0-ch2",
307 "clk-s-d3-fs0-ch2",
|
| D | at91-tse850-3.dts | 137 ch2-red {
141 ch2-green {
|
| D | r8a77470.dtsi | 148 "ch0", "ch1", "ch2", "ch3",
181 "ch0", "ch1", "ch2", "ch3",
|
| D | artpec6.dtsi | 254 "ch0", "ch1", "ch2", "ch3",
276 "ch0", "ch1", "ch2", "ch3",
|
| /Linux-v4.19/drivers/media/usb/pvrusb2/ |
| D | pvrusb2-context.c | 110 struct pvr2_channel *ch1, *ch2; in pvr2_context_check() local
139 for (ch1 = mp->mc_first; ch1; ch1 = ch2) { in pvr2_context_check()
140 ch2 = ch1->mc_next; in pvr2_context_check()
|
| /Linux-v4.19/include/linux/iio/common/ |
| D | st_sensors.h | 46 ch2, s, endian, rbits, sbits, addr) \ argument
53 .channel2 = ch2, \
|
| /Linux-v4.19/Documentation/devicetree/bindings/sound/ |
| D | st,sta32x.txt | 31 - st,ch2-output-mapping: Channel 2 output mapping
85 st,ch2-output-mapping = /bits/ 8 <0>; // set channel 2 output ch 1
|
| D | st,sta350.txt | 31 - st,ch2-output-mapping: Channel 2 output mapping
124 st,ch2-output-mapping = /bits/ 8 <0>; // set channel 2 output ch 1
|
| /Linux-v4.19/Documentation/devicetree/bindings/dma/ |
| D | renesas,rcar-dmac.txt | 74 "ch0", "ch1", "ch2", "ch3",
104 "ch0", "ch1", "ch2", "ch3",
|
| D | shdma.txt | 65 "ch0", "ch1", "ch2", "ch3",
|
| /Linux-v4.19/sound/oss/dmasound/ |
| D | dmasound_paula.c | 463 u_char *start, *ch0, *ch1, *ch2, *ch3; in AmiPlayNextFrame() local
500 ch2 = ch1+write_sq_block_size_quarter; in AmiPlayNextFrame()
503 custom.aud[2].audlc = (u_short *)ZTWO_PADDR(ch2); in AmiPlayNextFrame()
|
| /Linux-v4.19/Documentation/devicetree/bindings/clock/st/ |
| D | st,quadfs.txt | 43 "clk-s-c0-fs0-ch2",
|
| D | st,flexgen.txt | 46 | | ch2|----|-->| | | DIV | | DIV | | |
|
| /Linux-v4.19/scripts/ |
| D | Makefile.lib | 310 read ch0 ch1 ch2 ch3; \
311 for ch in $$ch3 $$ch2 $$ch1 $$ch0; do \
|
