| /Linux-v5.15/Documentation/devicetree/bindings/mfd/ |
| D | qcom,tcsr.txt | 9 "qcom,tcsr-ipq8064", "syscon" for IPQ8064
10 "qcom,tcsr-apq8064", "syscon" for APQ8064
11 "qcom,tcsr-msm8660", "syscon" for MSM8660
12 "qcom,tcsr-msm8960", "syscon" for MSM8960
13 "qcom,tcsr-msm8974", "syscon" for MSM8974
14 "qcom,tcsr-apq8084", "syscon" for APQ8084
15 "qcom,tcsr-msm8916", "syscon" for MSM8916
16 - reg: Address range for TCSR registers
19 tcsr: syscon@1a400000 {
20 compatible = "qcom,tcsr-msm8960", "syscon";
|
| /Linux-v5.15/drivers/soc/qcom/ |
| D | qcom_gsbi.c | 114 struct regmap *tcsr; member
118 { .compatible = "qcom,tcsr-ipq8064", .data = &config_ipq8064},
119 { .compatible = "qcom,tcsr-apq8064", .data = &config_apq8064},
120 { .compatible = "qcom,tcsr-msm8960", .data = &config_msm8960},
121 { .compatible = "qcom,tcsr-msm8660", .data = &config_msm8660},
147 /* get the tcsr node and setup the config and regmap */ in gsbi_probe()
148 gsbi->tcsr = syscon_regmap_lookup_by_phandle(node, "syscon-tcsr"); in gsbi_probe()
150 if (!IS_ERR(gsbi->tcsr)) { in gsbi_probe()
151 tcsr_node = of_parse_phandle(node, "syscon-tcsr", 0); in gsbi_probe()
157 dev_warn(&pdev->dev, "no matching TCSR\n"); in gsbi_probe()
[all …]
|
| D | cpr.c | 237 struct regmap *tcsr; member
393 static void cpr_set_acc(struct regmap *tcsr, struct fuse_corner *f, in cpr_set_acc() argument
401 regmap_multi_reg_write(tcsr, f->accs, f->num_accs); in cpr_set_acc()
404 regmap_multi_reg_write(tcsr, f->accs, f->num_accs); in cpr_set_acc()
414 if (drv->tcsr && dir == DOWN) in cpr_pre_voltage()
415 cpr_set_acc(drv->tcsr, prev_fuse_corner, fuse_corner); in cpr_pre_voltage()
426 if (drv->tcsr && dir == UP) in cpr_post_voltage()
427 cpr_set_acc(drv->tcsr, prev_fuse_corner, fuse_corner); in cpr_post_voltage()
1539 regmap_multi_reg_write(drv->tcsr, acc_desc->config, in cpr_pd_attach_dev()
1544 regmap_update_bits(drv->tcsr, acc_desc->enable_reg, in cpr_pd_attach_dev()
[all …]
|
| /Linux-v5.15/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,gsbi.txt | 20 - syscon-tcsr: indicates phandle of TCSR syscon node. Required if child uses
55 syscon-tcsr = <&tcsr>;
84 tcsr: syscon@1a400000 {
85 compatible = "qcom,apq8064-tcsr", "syscon";
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | qcom-msm8660.dtsi | 144 syscon-tcsr = <&tcsr>;
179 syscon-tcsr = <&tcsr>;
213 syscon-tcsr = <&tcsr>;
237 syscon-tcsr = <&tcsr>;
575 tcsr: syscon@1a400000 { label
576 compatible = "qcom,tcsr-msm8660", "syscon";
|
| D | qcom-mdm9615.dtsi | 227 syscon-tcsr = <&tcsr>;
251 syscon-tcsr = <&tcsr>;
403 tcsr: syscon@1a400000 { label
404 compatible = "qcom,tcsr-mdm9615", "syscon";
|
| D | qcom-msm8960.dtsi | 189 syscon-tcsr = <&tcsr>;
301 tcsr: syscon@1a400000 { label
302 compatible = "qcom,tcsr-msm8960", "syscon";
|
| D | qcom-ipq8064.dtsi | 521 syscon-tcsr = <&tcsr>;
558 syscon-tcsr = <&tcsr>;
595 syscon-tcsr = <&tcsr>;
644 syscon-tcsr = <&tcsr>;
777 tcsr: syscon@1a400000 { label
778 compatible = "qcom,tcsr-ipq8064", "syscon";
|
| D | qcom-apq8064.dtsi | 448 syscon-tcsr = <&tcsr>;
487 syscon-tcsr = <&tcsr>;
636 syscon-tcsr = <&tcsr>;
1145 tcsr: syscon@1a400000 { label
1146 compatible = "qcom,tcsr-apq8064", "syscon";
|
| /Linux-v5.15/Documentation/devicetree/bindings/hwlock/ |
| D | qcom-hwspinlock.yaml | 20 - qcom,tcsr-mutex
38 compatible = "qcom,tcsr-mutex";
|
| /Linux-v5.15/drivers/phy/qualcomm/ |
| D | phy-qcom-qusb2.c | 277 /* offset to PHY_CLK_SCHEME register in TCSR map */
419 * @tcsr: TCSR syscon register map
439 struct regmap *tcsr; member
793 * register in the TCSR so, if there's none, use the default in qusb2_phy_init()
804 if (qphy->tcsr) { in qusb2_phy_init()
805 ret = regmap_read(qphy->tcsr, qphy->cfg->clk_scheme_offset, in qusb2_phy_init()
1006 qphy->tcsr = syscon_regmap_lookup_by_phandle(dev->of_node, in qusb2_phy_probe()
1007 "qcom,tcsr-syscon"); in qusb2_phy_probe()
1008 if (IS_ERR(qphy->tcsr)) { in qusb2_phy_probe()
1009 dev_dbg(dev, "failed to lookup TCSR regmap\n"); in qusb2_phy_probe()
[all …]
|
| /Linux-v5.15/Documentation/mips/ |
| D | ingenic-tcu.rst | 19 different clocks (pclk, ext, rtc), gated, and reclocked, through their TCSR register.
21 - The watchdog and OST hardware blocks also feature a TCSR register with the same
|
| /Linux-v5.15/drivers/clk/ingenic/ |
| D | tcu.c | 134 WARN_ONCE(ret < 0, "Unable to read TCSR %d", tcu_clk->idx); in ingenic_tcu_get_parent()
150 WARN_ONCE(ret < 0, "Unable to update TCSR %d", tcu_clk->idx); in ingenic_tcu_set_parent()
167 WARN_ONCE(ret < 0, "Unable to read TCSR %d", tcu_clk->idx); in ingenic_tcu_recalc_rate()
213 WARN_ONCE(ret < 0, "Unable to update TCSR %d", tcu_clk->idx); in ingenic_tcu_set_rate()
|
| /Linux-v5.15/drivers/net/ethernet/marvell/mvpp2/ |
| D | mvpp2_tai.c | 242 u32 tcsr; in mvpp22_tai_gettimex64() local
260 tcsr = readl(base + MVPP22_TAI_TCSR); in mvpp22_tai_gettimex64()
261 if (tcsr & TCSR_CAPTURE_1_VALID) { in mvpp22_tai_gettimex64()
264 } else if (tcsr & TCSR_CAPTURE_0_VALID) { in mvpp22_tai_gettimex64()
|
| /Linux-v5.15/Documentation/devicetree/bindings/phy/ |
| D | qcom,qusb2-phy.yaml | 72 qcom,tcsr-syscon:
74 Phandle to TCSR syscon register region.
|
| /Linux-v5.15/drivers/rtc/ |
| D | rtc-rs5c348.c | 101 udelay(62); /* Tcsr 62us */ in rs5c348_rtc_set_time()
133 udelay(62); /* Tcsr 62us */ in rs5c348_rtc_read_time()
|
| /Linux-v5.15/Documentation/devicetree/bindings/firmware/ |
| D | qcom,scm.txt | 39 - qcom,dload-mode: phandle to the TCSR hardware block and offset of the
|
| /Linux-v5.15/Documentation/devicetree/bindings/remoteproc/ |
| D | qcom,q6v5.txt | 193 Definition: a phandle reference to a syscon representing TCSR followed
202 Definition: a phandle reference to a syscon representing TCSR followed
|
| D | qcom,hexagon-v56.txt | 75 Definition: a phandle reference to a syscon representing TCSR followed
|
| /Linux-v5.15/Documentation/translations/zh_CN/mips/ |
| D | ingenic-tcu.rst | 25 - 每个TCU通道都有自己的时钟源，可以通过 TCSR 寄存器设置通道的父级时钟
|
| /Linux-v5.15/Documentation/devicetree/bindings/power/avs/ |
| D | qcom,cpr.txt | 102 acc-syscon = <&tcsr>;
|
| /Linux-v5.15/drivers/firmware/ |
| D | qcom_scm.c | 1210 struct device_node *tcsr; in qcom_scm_find_dload_address() local
1216 tcsr = of_parse_phandle(np, "qcom,dload-mode", 0); in qcom_scm_find_dload_address()
1217 if (!tcsr) in qcom_scm_find_dload_address()
1220 ret = of_address_to_resource(tcsr, 0, &res); in qcom_scm_find_dload_address()
1221 of_node_put(tcsr); in qcom_scm_find_dload_address()
|
| /Linux-v5.15/arch/arm64/boot/dts/qcom/ |
| D | ipq6018.dtsi | 133 compatible = "qcom,tcsr-mutex";
261 tcsr: syscon@1937000 { label
606 qcom,halt-regs = <&tcsr 0x18000 0x1b000 0xe000>;
|
| /Linux-v5.15/drivers/clk/qcom/ |
| D | q6sstop-qcs404.c | 99 /* TCSR clock */
|
| /Linux-v5.15/drivers/hwspinlock/ |
| D | qcom_hwspinlock.c | 68 { .compatible = "qcom,tcsr-mutex" },
|
