1 /****************************************************************************** 2 * Filename: rf_ieee_mailbox.h 3 * 4 * Description: Definitions for IEEE 802.15.4 interface 5 * 6 * Copyright (c) 2015 - 2020, Texas Instruments Incorporated 7 * All rights reserved. 8 * 9 * Redistribution and use in source and binary forms, with or without 10 * modification, are permitted provided that the following conditions are met: 11 * 12 * 1) Redistributions of source code must retain the above copyright notice, 13 * this list of conditions and the following disclaimer. 14 * 15 * 2) Redistributions in binary form must reproduce the above copyright notice, 16 * this list of conditions and the following disclaimer in the documentation 17 * and/or other materials provided with the distribution. 18 * 19 * 3) Neither the name of the ORGANIZATION nor the names of its contributors may 20 * be used to endorse or promote products derived from this software without 21 * specific prior written permission. 22 * 23 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" 24 * AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 25 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 26 * ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE 27 * LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 28 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 29 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 30 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 31 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 32 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 33 * POSSIBILITY OF SUCH DAMAGE. 34 * 35 ******************************************************************************/ 36 37 #ifndef _IEEE_MAILBOX_H 38 #define _IEEE_MAILBOX_H 39 40 #include "rf_mailbox.h" 41 42 /// \name Radio operation status 43 ///@{ 44 /// \name Operation not finished 45 ///@{ 46 #define IEEE_SUSPENDED 0x2001 ///< Operation suspended 47 ///@} 48 /// \name Operation finished normally 49 ///@{ 50 #define IEEE_DONE_OK 0x2400 ///< Operation ended normally 51 #define IEEE_DONE_BUSY 0x2401 ///< CSMA-CA operation ended with failure 52 #define IEEE_DONE_STOPPED 0x2402 ///< Operation stopped after stop command 53 #define IEEE_DONE_ACK 0x2403 ///< ACK packet received with pending data bit cleared 54 #define IEEE_DONE_ACKPEND 0x2404 ///< ACK packet received with pending data bit set 55 #define IEEE_DONE_TIMEOUT 0x2405 ///< Operation ended due to timeout 56 #define IEEE_DONE_BGEND 0x2406 ///< FG operation ended because necessary background level 57 ///< operation ended 58 #define IEEE_DONE_ABORT 0x2407 ///< Operation aborted by command 59 ///@} 60 /// \name Operation finished with error 61 ///@{ 62 #define IEEE_ERROR_PAR 0x2800 ///< Illegal parameter 63 #define IEEE_ERROR_NO_SETUP 0x2801 ///< Operation using Rx or Tx attempted when not in 15.4 mode 64 #define IEEE_ERROR_NO_FS 0x2802 ///< Operation using Rx or Tx attempted without frequency synth configured 65 #define IEEE_ERROR_SYNTH_PROG 0x2803 ///< Synthesizer programming failed to complete on time 66 #define IEEE_ERROR_RXOVF 0x2804 ///< Receiver overflowed during operation 67 #define IEEE_ERROR_TXUNF 0x2805 ///< Transmitter underflowed during operation 68 ///@} 69 ///@} 70 71 #endif 72
