1 /****************************************************************************** 2 * Filename: rf_ble_mailbox.h 3 * 4 * Description: Definitions for BLE interface 5 * 6 * Copyright (c) 2015 - 2020, Texas Instruments Incorporated 7 * All rights reserved. 8 * 9 * Redistribution and use in source and binary forms, with or without 10 * modification, are permitted provided that the following conditions are met: 11 * 12 * 1) Redistributions of source code must retain the above copyright notice, 13 * this list of conditions and the following disclaimer. 14 * 15 * 2) Redistributions in binary form must reproduce the above copyright notice, 16 * this list of conditions and the following disclaimer in the documentation 17 * and/or other materials provided with the distribution. 18 * 19 * 3) Neither the name of the ORGANIZATION nor the names of its contributors may 20 * be used to endorse or promote products derived from this software without 21 * specific prior written permission. 22 * 23 * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" 24 * AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE 25 * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE 26 * ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE 27 * LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR 28 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF 29 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS 30 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN 31 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 32 * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE 33 * POSSIBILITY OF SUCH DAMAGE. 34 * 35 ******************************************************************************/ 36 37 #ifndef _BLE_MAILBOX_H 38 #define _BLE_MAILBOX_H 39 40 /// \name Radio operation status 41 ///@{ 42 /// \name Operation finished normally 43 ///@{ 44 #define BLE_DONE_OK 0x1400 ///< Operation ended normally 45 #define BLE_DONE_RXTIMEOUT 0x1401 ///< Timeout of first Rx of slave operation or end of scan window 46 #define BLE_DONE_NOSYNC 0x1402 ///< Timeout of subsequent Rx 47 #define BLE_DONE_RXERR 0x1403 ///< Operation ended because of receive error (CRC or other) 48 #define BLE_DONE_CONNECT 0x1404 ///< CONNECT_IND or AUX_CONNECT_RSP received or transmitted 49 #define BLE_DONE_MAXNACK 0x1405 ///< Maximum number of retransmissions exceeded 50 #define BLE_DONE_ENDED 0x1406 ///< Operation stopped after end trigger 51 #define BLE_DONE_ABORT 0x1407 ///< Operation aborted by command 52 #define BLE_DONE_STOPPED 0x1408 ///< Operation stopped after stop command 53 #define BLE_DONE_AUX 0x1409 ///< Operation ended after following aux pointer pointing far ahead 54 #define BLE_DONE_CONNECT_CHSEL0 0x140A ///< CONNECT_IND received or transmitted; peer does not support channel selection algorithm #2 55 #define BLE_DONE_SCAN_RSP 0x140B ///< SCAN_RSP or AUX_SCAN_RSP transmitted 56 ///@} 57 /// \name Operation finished with error 58 ///@{ 59 #define BLE_ERROR_PAR 0x1800 ///< Illegal parameter 60 #define BLE_ERROR_RXBUF 0x1801 ///< No available Rx buffer (Advertiser, Scanner, Initiator) 61 #define BLE_ERROR_NO_SETUP 0x1802 ///< Operation using Rx or Tx attempted when not in BLE mode 62 #define BLE_ERROR_NO_FS 0x1803 ///< Operation using Rx or Tx attempted without frequency synth configured 63 #define BLE_ERROR_SYNTH_PROG 0x1804 ///< Synthesizer programming failed to complete on time 64 #define BLE_ERROR_RXOVF 0x1805 ///< Receiver overflowed during operation 65 #define BLE_ERROR_TXUNF 0x1806 ///< Transmitter underflowed during operation 66 #define BLE_ERROR_AUX 0x1807 ///< Calculated AUX pointer was too far into the future or in the past 67 ///@} 68 ///@} 69 70 71 /// Special trigger for BLE slave command 72 #define BLE_TRIG_REL_SYNC 15 73 74 #endif 75
