1&pinctrl {
2	/* Configure pin control bias mode for SPI pins (MASTER) */
3	p10_0_scb1_spi_m_mosi: p10_0_scb1_spi_m_mosi {
4		pinmux = <DT_CAT1_PINMUX(10, 0, HSIOM_SEL_ACT_8)>;
5		drive-push-pull;
6	};
7
8	p10_1_scb1_spi_m_miso: p10_1_scb1_spi_m_miso {
9		pinmux = <DT_CAT1_PINMUX(10, 1, HSIOM_SEL_ACT_8)>;
10		input-enable;
11	};
12
13	p10_2_scb1_spi_m_clk: p10_2_scb1_spi_m_clk {
14		pinmux = <DT_CAT1_PINMUX(10, 2, HSIOM_SEL_ACT_8)>;
15		drive-push-pull;
16	};
17};
18
19spi: &scb1 {
20	compatible = "infineon,cat1-spi";
21	status = "okay";
22
23	pinctrl-0 = <&p10_0_scb1_spi_m_mosi &p10_1_scb1_spi_m_miso &p10_2_scb1_spi_m_clk>;
24	pinctrl-names = "default";
25	cs-gpios = <&gpio_prt10 3 GPIO_ACTIVE_LOW>;
26
27	slow@0 {
28		compatible = "test-spi-loopback-slow";
29		reg = <0>;
30		spi-max-frequency = <200000>;
31	};
32
33	fast@0 {
34		compatible = "test-spi-loopback-fast";
35		reg = <0>;
36		spi-max-frequency = <1500000>;
37	};
38};
39
40&gpio_prt10 {
41	status = "okay";
42};
43