1spi1: &scb3 {
2	compatible = "infineon,cat1-spi";
3	status = "okay";
4
5	pinctrl-0 = <&p6_0_scb3_spi_m_mosi &p6_1_scb3_spi_m_miso &p6_2_scb3_spi_m_clk>;
6	pinctrl-names = "default";
7	cs-gpios = <&gpio_prt6 3 GPIO_ACTIVE_LOW>;
8
9	slow@0 {
10		compatible = "test-spi-loopback-slow";
11		reg = <0>;
12		spi-max-frequency = <2000000>;
13	};
14	fast@0 {
15		compatible = "test-spi-loopback-fast";
16		reg = <0>;
17		spi-max-frequency = <3000000>;
18	};
19};
20
21&gpio_prt6 {
22	status = "okay";
23};
24
25&pinctrl {
26	/* Configure pin control bias mode for SPI pins */
27	p6_0_scb3_spi_m_mosi: p6_0_scb3_spi_m_mosi {
28		pinmux = <DT_CAT1_PINMUX(6, 0, HSIOM_SEL_ACT_8)>;
29		drive-push-pull;
30	};
31
32	p6_1_scb3_spi_m_miso: p6_1_scb3_spi_m_miso {
33		pinmux = <DT_CAT1_PINMUX(6, 1, HSIOM_SEL_ACT_8)>;
34		input-enable;
35	};
36
37	p6_2_scb3_spi_m_clk: p6_2_scb3_spi_m_clk {
38		pinmux = <DT_CAT1_PINMUX(6, 2, HSIOM_SEL_ACT_8)>;
39		drive-push-pull;
40	};
41};
42