1:orphan:
2
3.. rt1xxx-lpclink2-probes
4
5A debug probe is used for both flashing and debugging the board. This board has
6an :ref:`lpc-link2-onboard-debug-probe`. The default firmware present on this
7probe is the :ref:`lpclink2-daplink-onboard-debug-probe`.
8
9Based on the host tool installed, please use the following instructions
10to setup your debug probe:
11
12* :ref:`jlink-debug-host-tools`:
13  `Using J-Link with LPC-Link2 Probe`_
14* :ref:`linkserver-debug-host-tools`:
15  `Using CMSIS-DAP with LPC-Link2 Probe`_
16* :ref:`pyocd-debug-host-tools`:
17  `Using CMSIS-DAP with LPC-Link2 Probe`_
18
19Using CMSIS-DAP with LPC-Link2 Probe
20------------------------------------
21
221. Follow the instructions provided at
23   :ref:`lpclink2-cmsis-onboard-debug-probe` to reprogram the default debug
24   probe firmware on this board.
25#. Ensure the SWD isolation jumpers are populated
26
27Using J-Link with LPC-Link2 Probe
28---------------------------------
29
30There are two options: the onboard debug circuit can be updated with Segger
31J-Link firmware, or a :ref:`jlink-external-debug-probe` can be attached to the
32EVK.
33
34To update the onboard debug circuit, please do the following:
35
361. Switch the power source for the EVK to a different source than the
37   debug USB, as the J-Link firmware does not power the EVK via the
38   debug USB.
39#. Follow the instructions provided at
40   :ref:`lpclink2-jlink-onboard-debug-probe` to reprogram the default debug
41   probe firmware on this board.
42#. Ensure the SWD isolation jumpers are populated.
43
44To attach an external J-Link probe, ensure the SWD isolation jumpers are
45removed, then connect the probe to the external JTAG/SWD header
46