1:orphan:
2
3.. nxp-opensda-probes
4
5A debug probe is used for both flashing and debugging the board. This board has
6an :ref:`opensda-onboard-debug-probe`. The default firmware present on this
7probe is the :ref:`opensda-daplink-onboard-debug-probe`.
8
9Based on the host tool installed, please use the following instructions
10to setup your debug probe:
11
12* :ref:`jlink-debug-host-tools`: `Using J-Link on NXP OpenSDA Boards`_
13* :ref:`linkserver-debug-host-tools`: `Using DAPLink on NXP OpenSDA Boards`_
14* :ref:`pyocd-debug-host-tools`: `Using DAPLink on NXP OpenSDA Boards`_
15
16Using DAPLink on NXP OpenSDA Boards
17-----------------------------------
18
191. If the debug firmware has been modified, follow the instructions provided at
20   :ref:`opensda-daplink-onboard-debug-probe` to reprogram the default debug
21   probe firmware on this board.
22#. Ensure the SWD isolation jumpers are populated
23
24Using J-Link on NXP OpenSDA Boards
25----------------------------------
26
27There are two options: the onboard debug circuit can be updated with Segger
28J-Link firmware, or a :ref:`jlink-external-debug-probe` can be attached to the
29board.
30
31To update the onboard debug circuit, please do the following:
32
331. If the debug firmware has been modified, follow the instructions provided at
34   :ref:`opensda-jlink-onboard-debug-probe` to reprogram the default debug
35   probe firmware on this board.
36#. Ensure the SWD isolation jumpers are removed.
37
38To attach an external J-Link probe, ensure the SWD isolation jumpers are
39removed, and connect the external probe to the JTAG/SWD header.
40