1# Note: Using OpenOCD using nucloe_wba52cg requires using STMicroelectronics
2# openocd fork. See board documentation for more information
3
4source [find interface/stlink-dap.cfg]
5
6set WORKAREASIZE 0x8000
7
8transport select "dapdirect_swd"
9
10# Enable debug when in low power modes
11set ENABLE_LOW_POWER 1
12
13# Stop Watchdog counters when halt
14set STOP_WATCHDOG 1
15
16# STlink Debug clock frequency
17set CLOCK_FREQ 8000
18
19# Reset configuration
20# use hardware reset, connect under reset
21# connect_assert_srst needed if low power mode application running (WFI...)
22reset_config srst_only srst_nogate
23
24source [find target/stm32wbax.cfg]
25