1#
2# Copyright 2022 NXP
3#
4# SPDX-License-Identifier: Apache-2.0
5#
6
7if(CONFIG_NXP_IMX_RT_BOOT_HEADER)
8  zephyr_library()
9  if(NOT (DEFINED CONFIG_BOARD_MIMXRT1160_EVK_CM7)
10    OR (DEFINED CONFIG_BOARD_MIMXRT1160_EVK_CM4))
11    message(WARNING "It appears you are using the board definition for "
12     "the MIMXRT1160-EVK, but targeting a custom board. You may need to "
13     "update your flash configuration or device configuration data blocks")
14  endif()
15  set(RT1160_BOARD_DIR
16    "${ZEPHYR_HAL_NXP_MODULE_DIR}/mcux/mcux-sdk/boards/evkmimxrt1160")
17  if(CONFIG_BOOT_FLEXSPI_NOR)
18    # Include flash configuration block for RT1160 EVK from NXP's HAL.
19    # This configuration block may need modification if another flash chip is
20    # used on your custom board. See NXP AN12238 for more information.
21    zephyr_compile_definitions(XIP_BOOT_HEADER_ENABLE=1)
22    zephyr_compile_definitions(BOARD_FLASH_SIZE=CONFIG_FLASH_SIZE*1024)
23    zephyr_library_sources(${RT1160_BOARD_DIR}/xip/evkmimxrt1160_flexspi_nor_config.c)
24    zephyr_library_include_directories(${RT1160_BOARD_DIR}/xip)
25  endif()
26  if(CONFIG_DEVICE_CONFIGURATION_DATA)
27    # Include device configuration data block for RT1160 EVK from NXP's HAL.
28    # This configuration block may need modification if another SDRAM chip
29    # is used on your custom board.
30    zephyr_compile_definitions(XIP_BOOT_HEADER_DCD_ENABLE=1)
31    zephyr_library_sources(${RT1160_BOARD_DIR}/dcd.c)
32  endif()
33endif()
34
35if(CONFIG_MCUX_GPT_TIMER)
36  message(WARNING "You appear to be using the GPT hardware timer. "
37    "This timer will enable lower power modes, but at the cost of reduced "
38    "hardware timer resolution")
39endif()
40