Searched refs:requires (Results 201 – 225 of 641) sorted by relevance
12345678910>>...26
61 secure and non-secure binaries on certain platforms also requires the use of
6 automated testing. It requires two serial ports to operate.
17 Practical use of this sample requires a sink (e.g. the BAP Broadcast Audio Sink sample or
15 Enable system tracing. This requires a backend such as SEGGER87 Enable synchronous tracing. This requires the backend to be232 Enable tracing ISRs. This requires the backend to be
43 The board Bluetooth/WiFi module requires fetching some binary blob files, to do55 The dual core nature of STM32H747 SoC requires sharing HW resources between the
38 cy8cproto_063_ble board requires fetch binary files68 .. note:: Linux requires device access rights to be set up for KitProg3. This is handled automatica…
82 bootloader, and another by using the SWD debug port (which requires additional83 hardware). Flashing using the ROM bootloader requires a special activation
103 M5Stack StampS3 requires a single 5V input power supply. The module internally123 Espressif HAL requires WiFi and Bluetooth binary blobs in order work. Run the command
79 bootloader, and another by using the SWD debug port (which requires additional80 hardware). Flashing using the ROM bootloader requires a special activation
198 firmware image using Zephyr requires the following steps:202 To invoke the building of TF-M the Zephyr build system requires the226 using Zephyr requires the following steps:276 Flashing and debugging applications on the nRF5340 DK requires
47 # The MWDT compiler requires different macro definitions for ARC and RISC-V
26 CONFIG_BOARD_NATIVE_POSIX, or requires other kconfig options which depend on it.
84 The LP_EM_CC2340R5 requires an external debug probe such as the LP-XDS110 or
21 #error Meta-IRQ test requires single-CPU operation
42 ``west flash`` requires `SEGGER J-Link software`_ and `pylink`_ Python module
43 ``west flash`` requires `SEGGER J-Link software`_ and `pylink`_ Python module
23 The sample requires a servomotor whose signal pin is connected to a pin driven
27 This sample requires a board with a CAN controller. The CAN controller must be configured using the
99 handshake used in the commissioning procedure requires a larger205 handshake used in the commissioning procedure requires a larger291 This requires a crypto backend library that supports key references.
43 during startup and it requires no intervention from the MCU side.
48 * Each enabled channel requires 256 bytes in _sw_isr_table, so the savings for
36 Espressif HAL requires WiFi and Bluetooth binary blobs in order work. Run the command
29 # At the same time zephyr-SDK requires ARCH variable to be initialized before include "generic.cmak…
