Home
last modified time | relevance | path

Searched refs:either (Results 76 – 100 of 370) sorted by relevance

12345678910>>...15

/Zephyr-latest/samples/subsys/shell/devmem_load/
DREADME.md38 You can either type it directly from the console or send it from the host PC (replace `ttyX` with t…
/Zephyr-latest/doc/connectivity/networking/
Dnative_sim_setup.rst24 On the Linux Host, find the Zephyr `net-tools`_ project, which can either be
120 On the Linux Host, find the Zephyr `net-tools`_ project, which can either be
Dqemu_eth_setup.rst21 On the Linux Host, find the Zephyr `net-tools`_ project, which can either be
Dnetwork_monitoring.rst26 On the Linux Host, find the Zephyr `net-tools`_ project, which can either be
217 After enabling the monitoring, the system will send captured (either received
243 You can monitor either the tunnel interfaces or the ``zeth`` interface.
/Zephyr-latest/boards/arduino/giga_r1/doc/
Dindex.rst67 using either ``arduino_giga_r1/stm32h747xx/m7`` or ``arduino_giga_r1/stm32h747xx/m4`` as the target.
74 This board can be flashed either using dfu-util, or with an external debugging
/Zephyr-latest/doc/connectivity/bluetooth/
Dbluetooth-dev.rst88 Certain external Controllers are either unable to accept the Host to
152 devices in either of :ref:`these boards's documentation <nrf52bsim_build_and_run>`.
159 With the :ref:`nrf5340bsim <nrf5340bsim>`, you can build with either, both controller and host
/Zephyr-latest/include/zephyr/linker/
Dcommon-ram.ld66 /* All kernel objects within are assumed to be either completely
/Zephyr-latest/boards/nxp/ucans32k1sic/doc/
Dindex.rst68 The UCANS32K1SIC board has one user RGB LED that can be used either as a GPIO
158 application is downloaded to either Flash or SRAM. This routine takes time to
/Zephyr-latest/doc/hardware/peripherals/can/
Dcontroller.rst62 This identifier can either have 11-bit width (Standard or Basic Frame) or
75 Filters can either match exactly or a specified part of the identifier.
85 Error-frames can either be error passive or error active, depending on the state
100 If either the receive- or the transmit-error counter exceeds 127,
/Zephyr-latest/doc/develop/flash_debug/
Dnordic_segger.rst58 Where ``<x>`` is either 1 for nRF51-based boards or 2 for nRF52-based boards
67 and ``<x>`` is either 1 for nRF51-based boards or 2 for nRF52-based boards
75 Where ``<x>`` is either 1 for nRF51-based boards or 2 for nRF52-based boards
/Zephyr-latest/boards/nxp/ucans32k1sic/support/
Dstartup.cmm17 ; erased before the application is downloaded to either Flash *
/Zephyr-latest/samples/net/sockets/websocket_client/
DREADME.rst67 In a terminal window you can do either:
/Zephyr-latest/samples/subsys/llext/modules/
DREADME.rst6 either built-in or loaded at runtime.
/Zephyr-latest/boards/amd/acp_6_0_adsp/doc/
Dindex.rst10 SOF can be built with either Zephyr or Cadence's proprietary
/Zephyr-latest/samples/boards/96boards/argonkey/sensors/
DREADME.rst16 in either one of the following two ways:
/Zephyr-latest/samples/bluetooth/mesh/
DREADME.rst57 The sample can either be provisioned into an existing mesh network with an
/Zephyr-latest/drivers/espi/
DKconfig67 to prepare for either HOST suspend or reset.
77 This depends on SPI boot configuration. It could be either very
/Zephyr-latest/doc/develop/west/
Dworkspaces.rst26 update``. Instead, check out a local branch with another name, and either
54 You can either enter the password manually or use any of the `credential
198 │   └── zcbor/ # .git/ project from either the main manifest or some import.
289 │   └── zcbor/ # .git/ project from either the main manifest or
/Zephyr-latest/drivers/sensor/adi/adxl362/
DKconfig154 mode in either absolute or referenced mode.
/Zephyr-latest/boards/shields/ls0xx_generic/doc/
Dindex.rst23 This signal must be supplied from either serial input (sw) or an external
/Zephyr-latest/subsys/mgmt/osdp/
DKconfig35 OSDP defines that baud rate can be either 9600 or 38400 or
/Zephyr-latest/boards/nxp/mr_canhubk3/support/
Dstartup.cmm16 ; erased before the application is downloaded to either Flash *
/Zephyr-latest/tests/arch/arm/arm_thread_swap/
DREADME.txt19 - the mode variable (when building with support for either user
/Zephyr-latest/dts/common/nordic/
Dnrf54l09.dtsi268 * This spi node can be either SPIM or SPIS,
307 * This spi node can be either SPIM or SPIS,
458 * This spi node can be either SPIM or SPIS,
/Zephyr-latest/share/sysbuild/images/bootloader/
DKconfig91 can boot from either partition and will select one with higher application image version,
101 will boot the application with the higher version from either slot, as long as it has

12345678910>>...15