Searched full:manually (Results 1 – 25 of 301) sorted by relevance
12345678910>>...13
15 * LED1 connection must be manually established using a jumper between23 * LED2 connection must be manually established using a jumper between61 * Interrupt connection must be manually established using a jumper wire between
18 * @brief Manually reset a PCAL64XXA20 * Resetting a PCAL64XXA manually is only necessary if the by default
9 block address must be set manually within SystemView or the RTT Viewer. The14 The RTT control block address must be provided manually because this SOC
36 whatever was manually set.53 whatever was manually set.
29 # we rely on default MWDT header locations and don't manually specify headers directories.42 # manually call __builtin_** functions even if we specify it.
15 Manually set 28th bit in the LINEADDR in Trustzone Secure build.
10 Enable NXP ENET MDIO Driver. This Kconfig can be disabled manually
6 # defined CONFIG_X86 manually. To consider, is ARCH_POSIX a better choice?
14 /* On NET core we don't use Zephyr's shim layer so we have to call inits manually */ in serialization_init()
7 # So here we are, tuning this manually.
20 driver. This requires manually packing each byte with a data/command
34 you will need to manually clone the additional projects listed in the53 without west installed if you specify any modules manually.91 by manually creating a :term:`west workspace`:
19 # Such option should not be configured manually but by device drivers
7 * Do not manually edit.
24 * We still need to install the stdout callback manually at run time. in semihost_console_init()
15 # DTS file, so we manually override FLASH_LOAD_OFFSET to link the application
12 # DTS file, so we manually override FLASH_LOAD_OFFSET to link the application
13 # DTS file, so we manually override FLASH_LOAD_OFFSET to link the application
43 This can be manually used if no other value is readily available, but
56 # Configure the OpenThread manually
112 /* Manually set the sub-GHZ antenna switch DIO */ in board_cc13xx_rf_callback()120 /* Manually set the 2.4GHZ antenna switch DIO */ in board_cc13xx_rf_callback()
37 the backend manually using log_backend_enable().
18 your path. This can be setup using chocolatey or by manually installing it.
26 # Do not edit it manually.51 * Do not edit it manually.
