| /hal_espressif-latest/components/spi_flash/ |
| D | spi_flash_hpm_enable.c | 190 * Usually, the bits are at bit-0, bit-1, sr-3 and set DC[1:0]=[1,1].
205 * @brief Check whether HPM has been enabled. This function checks the DC bits
226 #warning HPM-DC, which helps to run some flash > 80MHz by adjusting dummy cycles, is no longer enab…
328 ESP_EARLY_LOGI(HPM_TAG, "w/o HPM-DC support"); in spi_flash_enable_high_performance_mode()
331 ESP_EARLY_LOGI(HPM_TAG, "with HPM-DC support"); in spi_flash_enable_high_performance_mode()
334 …ESP_EARLY_LOGW(HPM_TAG, "HPM mode with DC adjustment is disabled. Some flash models may not be sup… in spi_flash_enable_high_performance_mode()
|
| D | Kconfig | 66 prompt "Support HPM using DC (READ DOCS FIRST)"
70 …This feature needs your bootloader to be compiled DC-aware (BOOTLOADER_FLASH_DC_AWARE=y). Otherwis…
83 … This is a helper config for HPM. Whether HPM-DC is enabled is also determined by bootloader.
|
| /hal_espressif-latest/components/hal/esp32s3/include/hal/ |
| D | lcd_ll.h | 377 * @brief Set the level state of DC line, on different transaction phases
380 * @param idle_phase Level state of DC line on IDLE phase
381 * @param cmd_phase Level state of DC line on CMD phase
382 * @param dummy_phase Level state of DC line on DUMMY phase
383 * @param data_phase Level state of DC line on DATA phase
395 * @brief Set cycle of delay for DC line
|
| /hal_espressif-latest/components/hal/esp32/include/hal/ |
| D | dac_ll.h | 165 * Set the voltage value of the DC component of the cosine wave generator output.
167 * @note The DC offset setting should be after phase setting.
170 * @param offset DC value. Range: -128 ~ 127.
|
| /hal_espressif-latest/components/hal/esp32s2/include/hal/ |
| D | dac_ll.h | 186 * Set the voltage value of the DC component of the cosine wave generator output.
188 * @note The DC offset setting should be after phase setting.
191 * @param offset DC value. Range: -128 ~ 127.
|
| /hal_espressif-latest/components/driver/deprecated/driver/ |
| D | dac_types_legacy.h | 73 …int8_t offset; /*!< Set the voltage value of the DC component of the cosine wave generato…
|
| /hal_espressif-latest/components/soc/esp32s2/include/soc/ |
| D | sens_struct.h | 312 uint32_t dac_dc1: 8; /*DC offset for DAC1 CW generator*/
313 uint32_t dac_dc2: 8; /*DC offset for DAC2 CW generator*/
|
| D | sens_reg.h | 1128 /*description: DC offset for DAC2 CW generator*/
1134 /*description: DC offset for DAC1 CW generator*/
|
| /hal_espressif-latest/components/esp_hw_support/port/esp32s3/ |
| D | mspi_timing_config.c | 122 if (spi_flash_hpm_dummy_adjust()) { // HPM-DC is enabled in spi_timing_config_get_dummy()
142 { // HPM-DC is not enabled in spi_timing_config_get_dummy()
|
| /hal_espressif-latest/components/esp_phy/include/esp_private/ |
| D | phy.h | 136 …* @attention 1.This is a workaround to improve Wi-Fi receive 11b pkts for some modules using AC-DC…
|
| /hal_espressif-latest/components/esp_rom/include/esp32c3/rom/ |
| D | tjpgd.h | 73 SHORT dcv[3]; /* Previous DC element of each component */
|
| /hal_espressif-latest/components/esp_rom/include/esp32c6/rom/ |
| D | tjpgd.h | 78 SHORT dcv[3]; /* Previous DC element of each component */
|
| /hal_espressif-latest/components/esp_phy/ |
| D | Kconfig | 165 …This is a workaround to improve Wi-Fi receive 11b pkts for some modules using AC-DC power supply w…
|
| /hal_espressif-latest/components/esp_rom/include/esp32s3/rom/ |
| D | tjpgd.h | 73 SHORT dcv[3]; /* Previous DC element of each component */
|
| /hal_espressif-latest/components/esp_rom/include/esp32/rom/ |
| D | tjpgd.h | 73 SHORT dcv[3]; /* Previous DC element of each component */
|
| /hal_espressif-latest/zephyr/esp32s3/src/ |
| D | soc_flash_init.c | 248 /* Reset flash, clear volatile bits DC[0:1]. Make it work under default mode to boot. */ in init_spi_flash()
|
| /hal_espressif-latest/components/bootloader_support/bootloader_flash/src/ |
| D | bootloader_flash_config_esp32s3.c | 264 // Reset flash, clear volatile bits DC[0:1]. Make it work under default mode to boot. in bootloader_init_spi_flash()
|
| /hal_espressif-latest/zephyr/port/pincfgs/ |
| D | esp32s3.yml | 557 dc:
|
| /hal_espressif-latest/components/bt/host/bluedroid/stack/btu/ |
| D | btu_hcif.c | 675 DEV_CLASS dc; in btu_hcif_connection_request_evt() local
679 STREAM_TO_DEVCLASS (dc, p); in btu_hcif_connection_request_evt()
685 btm_sec_conn_req (bda, dc); in btu_hcif_connection_request_evt()
690 btm_sco_conn_req (bda, dc, link_type); in btu_hcif_connection_request_evt()
|
| /hal_espressif-latest/components/bt/host/bluedroid/stack/avct/ |
| D | avct_l2c.c | 357 AVCT_TRACE_DEBUG("ch_state dc: %d ", p_lcb->ch_state); in avct_l2c_disconnect_cfm_cback()
|
| /hal_espressif-latest/components/bt/host/bluedroid/stack/btm/include/ |
| D | btm_int.h | 1044 void btm_acl_created (BD_ADDR bda, DEV_CLASS dc, UINT8 bdn[BTM_MAX_REM_BD_NAME_LEN],
1183 void btm_sec_conn_req (UINT8 *bda, UINT8 *dc);
|
| /hal_espressif-latest/components/soc/esp32/include/soc/ |
| D | sens_reg.h | 949 /*description: DC offset for DAC2 CW generator*/
955 /*description: DC offset for DAC1 CW generator*/
|
| /hal_espressif-latest/components/bt/host/bluedroid/stack/btm/ |
| D | btm_inq.c | 1818 DEV_CLASS dc; in btm_process_inq_results() local
1844 STREAM_TO_DEVCLASS (dc, p); in btm_process_inq_results()
1935 p_cur->dev_class[0] = dc[0]; in btm_process_inq_results()
1936 p_cur->dev_class[1] = dc[1]; in btm_process_inq_results()
1937 p_cur->dev_class[2] = dc[2]; in btm_process_inq_results()
|
| D | btm_acl.c | 242 void btm_acl_created (BD_ADDR bda, DEV_CLASS dc, UINT8 bdn[BTM_MAX_REM_BD_NAME_LEN], in btm_acl_created() argument
306 if (dc) { in btm_acl_created()
307 memcpy (p->remote_dc, dc, DEV_CLASS_LEN); in btm_acl_created()
|
| /hal_espressif-latest/components/bt/host/bluedroid/bta/dm/include/ |
| D | bta_dm_int.h | 568 DEV_CLASS dc; member
|
