Searched refs:SB4 (Results 1 – 7 of 7) sorted by relevance
| /Zephyr-latest/boards/st/nucleo_wl55jc/ |
| D | st_morpho_connector.dtsi | 55 <ST_MORPHO_R_37 0 &gpiob 7 0>, /* SB9=ON, SB4=OFF, SB10=OFF */
|
| /Zephyr-latest/boards/st/nucleo_g070rb/ |
| D | st_morpho_connector.dtsi | 38 <ST_MORPHO_L_36 0 &gpiob 11 0>, /* SB4=ON, SB2=OFF */
|
| /Zephyr-latest/boards/st/nucleo_g071rb/ |
| D | st_morpho_connector.dtsi | 38 <ST_MORPHO_L_36 0 &gpiob 11 0>, /* SB4=ON, SB2=OFF */
|
| /Zephyr-latest/boards/st/nucleo_g0b1re/ |
| D | st_morpho_connector.dtsi | 38 <ST_MORPHO_L_36 0 &gpiob 11 0>, /* SB4=ON, SB2=OFF */
|
| /Zephyr-latest/boards/weact/stm32g431_core/doc/ |
| D | index.rst | 17 lines to the MCU. The voltage divider is connected to PB2 by closing SB4.
83 | SB4 | Open | Connect PB2 to VBUS voltage divider |
|
| /Zephyr-latest/boards/st/stm32h7b3i_dk/ |
| D | stm32h7b3i_dk.dts | 160 /* Connect solder bridges SB3, SB4 and SB5 to use CAN connector (CN21) */
|
| /Zephyr-latest/boards/st/stm32h7b3i_dk/doc/ |
| D | index.rst | 273 .. [#] To use CAN, solder bridges SB3, SB4 and SB5 need to be connected.
|
