Home
last modified time | relevance | path

Searched refs:fuses (Results 1 – 5 of 5) sorted by relevance

/Zephyr-Core-3.7.0/samples/boards/mimxrt595_evk/system_off/
DREADME.rst71 the One-Time-Programmable (OTP) fuses in the MCU. The steps below detail
72 how program the OTP BOOT_CFG1 fuses to use GPIO pin PIO4_5 as the flash
77 fuses must match the GPIO pin connected to reset. Before programming
78 fuses, it is best to write the OTP shadow registers first and confirm
79 the operation. Then program the OTP fuses after confirming the correct
80 settings. For more details on OTP fuses and shadow registers, refer to
89 program the OTP fuses. To download, go to https://www.nxp.com/mcuboot,
92 Steps to program OTP fuses on MIMXRT595-EVK
108 4. This command confirms the current settings of BOOT_CFG1 fuses:
115 6. This command confirms the programmed fuses in BOOT_CFG1:
/Zephyr-Core-3.7.0/drivers/disk/nvme/
Dnvme.h291 uint16_t fuses; member
379 s->fuses = sys_le16_to_cpu(s->fuses); in nvme_controller_data_swapbytes()
/Zephyr-Core-3.7.0/samples/tfm_integration/psa_protected_storage/
DREADME.rst14 fuses, etc.
/Zephyr-Core-3.7.0/boards/96boards/avenger96/doc/
Dindex.rst140 - 3072-bit fuses including 96-bit unique ID, up to 1184-bit available for user
/Zephyr-Core-3.7.0/boards/st/stm32mp157c_dk2/doc/
Dstm32mp157_dk2.rst151 - 3072-bit fuses including 96-bit unique ID, up to 1184-bit available for user