Searched full:workaround (Results 1 – 25 of 269) sorted by relevance
1234567891011
78 int "Anomaly 132 workaround delay (microseconds)"91 depending on application, workaround may also need to be applied.93 may be shortened. Workaround is disabled by setting delay to 0.96 bool "Anomaly 198 workaround"105 bool "Anomaly 109 workaround"116 int "Anomaly 109 workaround EGU instance"121 EGU instance used by the nRF52 Anomaly 109 workaround for PWM.
11 workaround:14 Define the applied workaround for the switch used for15 short connections. Use bitmask to select the workaround or more
44 bool "Workaround for nRF5340 anomaly 160"49 Indicates that the workaround for the anomaly 160 that affects54 If this option is enabled, but the workaround cannot be applied,64 bool "Workaround for nRF5340 anomaly 168"67 Indicates that the workaround for the anomaly 168 that affects69 The workaround involves execution of 8 NOP instructions when the CPU74 bool "Extend the workaround to execution at 128 MHz from RAM"77 Indicates that the anomaly 168 workaround is to be extended to cover83 bool "Pre-tick workaround for nRF5340 anomaly 165"89 Indicates that the pre-tick workaround for the anomaly 165 that affects[all …]
13 nRF5340 SoC. The related workaround cannot be applied, because your15 Consider enabling the system clock to apply the workaround.
27 /* Temporary workaround to reserve P1.03 for cpuapp */32 /* Temporary workaround to reserve P1.02 for cpuapp */
16 - name: Apply container owner mismatch workaround20 # Actions runner is implemented. Remove this workaround when
11 anomaly-58-workaround:14 Enables the workaround for the nRF52832 SoC SPIM PAN 58 anomaly.
81 'anomaly-58-workaround' a workaround can be enabled per SPIM85 enabling 'anomaly-58-workaround' via the Devicetree.
2 # Workaround for #21372. This allows OpenOCD to flash correctly
3 # Workaround for issue where SDMA driver needs to start before camera, so that
9 # Workaround for incorrect SYS_CLOCK_HW_CYCLES_PER_SEC
10 # Workaround for incorrect SYS_CLOCK_HW_CYCLES_PER_SEC
10 # Workaround: Unable to allocate command buffer when using K_NO_WAIT since
4 # Workaround for pretending that the controller
1 # Copyright (c) 2018 Workaround GmbH
4 # Workaround for not being able to have commas in macro arguments
6 # Workaround for not being able to have commas in macro arguments
21 Workaround the issue "Possible Hang-Up After VCC1_RST Reset"
20 # Workaround: Unable to allocate command buffer when using K_NO_WAIT since
15 # Workaround: Unable to allocate command buffer when using K_NO_WAIT since
9 # Workaround for not being able to have commas in macro arguments
