Searched full:wired (Results 1 – 25 of 58) sorted by relevance
123
11 wired up to your IS31FL3733 LED driver. The sample will only attempt18 Set this to match the number of CS LED source connections wired up
44 /* Indicates single ended open drain mode (wired AND). */46 /* Indicates single ended open source mode (wired OR). */51 /** Configures GPIO output in open drain mode (wired AND).58 /** Configures GPIO output in open source mode (wired OR).
24 * When the pin is configured to operate in open-drain mode (wired-and), the27 * (wired-or), the drive mode can only be set for the 1 level
5 where two GPIOs are directly wired together. The test pins are19 FATAL output pin not wired to input pin? (out high => in low)
72 /** @brief Wired External Power Source Status74 * Enumeration for the status of the wired external power source.77 /** Wired external power source is not connected. */80 /** Wired external power source is connected. */83 /** Wired external power source status is unknown. */231 * @brief Set the wired external power source status.233 * @param source The wired external power source status to set.
15 * wired to i2c0 and PTC2 externally
15 * wired to i2c1 externally.
13 to be instantiated. Furthermore, the emulated pins can be "wired"
15 and neighbors on a wired Ethernet network.
50 If you wired the sensor to a SPI peripheral on an Arduino header, build and65 If you wired the sensor to an I2C peripheral on an Arduino header, build and81 to GPIO16 through GPIO19. With the sensor wired to those lines, build and91 demonstrates using PIO SPI with the sensor wired to arbitrary GPIO pins.
17 sample overlay is provided for the ``nucleo_f746zg`` board fly-wired to a Hitachi
18 LEDs in an array/strip are not wired following the LED order of
27 This structure is called a wired-AND.
31 With the sensor wired to the desired pins, build and flash with:
17 - MAX6675 wired to your board SPI bus
28 The easiest way to get this wired is to use the Grove shield and connect both
38 _is31fl3216a LED driver (with 16 LEDs wired) is connected to the I2C bus at
11 UART to USB bridge dongles that are wired together, writing demo data to one24 #. Two UART to USB bridge dongles. Each dongle must have its TX pin wired to the
187 wired from the serial port to the ESP32. Most USB development208 wired from the serial port to the ESP32. Most USB development
65 - drive-open-drain: Configure GPIO to open-drain (wired-AND) mode.66 - drive-open-source: Configure GPIO to open-source (wired-OR) mode.
19 The shield needs to be wired to a host board supporting the Arduino connector.
40 LED driver (with 10 LEDs wired) is connected to the I2C0 bus at address 0x30.
68 * Each agent is wired to its own interrupt.
67 * Each agent is wired to its own interrupt.
