Searched full:suggests (Results 1 – 21 of 21) sorted by relevance
| /Zephyr-latest/dts/bindings/gpio/ |
| D | zephyr,gpio-emul-sdl.yaml | 21 The "typical position" column from HID table suggests to match them
|
| /Zephyr-latest/subsys/net/ip/ |
| D | Kconfig.tcp | 55 the same local/remote ports, RFC 793 (TCP) suggests to keep
58 suggests to use MSL of 2 minutes, but notes "This is an
|
| /Zephyr-latest/doc/services/resource_management/ |
| D | index.rst | 11 suggests that a shared implementation is desirable.
|
| /Zephyr-latest/boards/sc/scobc_module1/doc/ |
| D | index.rst | 13 As the name suggests, the board form factor is a module and requires a base I/O
|
| /Zephyr-latest/doc/connectivity/networking/ |
| D | net_config_guide.rst | 159 `RFC 793 <https://www.rfc-editor.org/rfc/rfc793>`_ (TCP) suggests
162 suggests to use MSL of 2 minutes, but notes
|
| /Zephyr-latest/doc/kernel/data_structures/ |
| D | rbtree.rst | 22 operations are attempted. This function should, as its name suggests,
|
| /Zephyr-latest/drivers/dma/ |
| D | dma_nxp_sof_host_dma.c | 30 * As its name suggests, its only usage is in SOF
|
| /Zephyr-latest/tests/bluetooth/tester/src/ |
| D | btp_ots.c | 155 /* TS suggests to use OTS service UUID for testing this */ in ots_obj_created()
|
| /Zephyr-latest/boards/shields/esp_8266/doc/ |
| D | index.rst | 92 The below table suggests shield variation accordingly with end user
|
| /Zephyr-latest/drivers/i2c/ |
| D | i2c_bitbang.c | 283 * rev. 6, section 3.1.16) suggests the master emit 9 SCL in i2c_bitbang_recover_bus()
|
| /Zephyr-latest/drivers/flash/ |
| D | flash_ifx_cat1_qspi.c | 77 /* The number of dummy cycles. A zero value suggests no dummy cycles. */
|
| /Zephyr-latest/boards/others/stm32_min_dev/doc/ |
| D | index.rst | 16 As the name suggests, these boards have the bare minimum components required to
|
| /Zephyr-latest/boards/shields/inventek_eswifi/doc/ |
| D | index.rst | 91 The below table suggests shield variation accordingly with end user
|
| /Zephyr-latest/boards/shields/atmel_rf2xx/doc/ |
| D | index.rst | 227 The below table suggests shield variation accordingly with end user
|
| /Zephyr-latest/subsys/bluetooth/host/ |
| D | l2cap.c | 730 * refs suggests a silent data corruption would occur if not for in bt_l2cap_send_pdu()
3230 * refs suggests a silent data corruption would occur if not for in bt_l2cap_dyn_chan_send()
|
| /Zephyr-latest/drivers/can/ |
| D | can_mcp251xfd.c | 1386 * However, it needs to be properly handled if other values are needed. Errata suggests in mcp251xfd_init_iocon_reg()
|
| /Zephyr-latest/doc/releases/ |
| D | release-notes-3.6.rst | 1054 that suggests pointer casting must be added.
|
| D | release-notes-3.0.rst | 1078 * :github:`40999` - Unable to boot smp_svr sample image as documentation suggests, or sign
|
| /Zephyr-latest/subsys/bluetooth/controller/ll_sw/ |
| D | ull_llcp.c | 908 * but nothing in the specification seems to suggests in ull_cp_data_length_update()
|
| /Zephyr-latest/drivers/ethernet/ |
| D | eth_sam_gmac.c | 1108 /* For multiple priority queues, 802.1Qav suggests using 75% for the in gmac_init()
|
| /Zephyr-latest/samples/modules/tflite-micro/hello_world/train/ |
| D | train_hello_world_model.ipynb | 1699 …"The rigidity of this fit suggests that the model does not have enough capacity to learn the full …
|
