Searched full:stop3 (Results 1 – 11 of 11) sorted by relevance
2 :name: STOP3 mode4 Use STOP3 low power mode on STM32U5.10 behavior in a basic blinking LED set up and STM32U5 STOP3 low power mode.12 .. _stm32-pm-stop3-requirements:27 :zephyr-app: samples/boards/st/power_mgmt/stop3
2 name: STM32 STOP3 Power Management4 sample.boards.stm32.power_mgmt.stop3:
36 * This configuration is active only in STOP3 mode, so no need to disable it in main()43 /* In STOP3, GPIOs are disabled. Only pull-up/pull-down can be enabled. in main()
14 cpu-power-states = <&stop0 &stop1 &stop2 &stop3>;
27 Enable support for STM32 STOP3 low-power mode.
72 case 4: /* enter STOP3 mode */ in set_mode_stop()
73 Same approach is used on STM32U5 and STOP3 mode.
208 /* Check if STANBY or STOP3 is requested */ in sys_clock_set_timeout()
280 ('samples/boards/stm32/power_mgmt/stop3/README', 'samples/boards/st/power_mgmt/stop3/README'),
68 /omit-if-no-ref/ stop3: state3 {
386 * STM32U5: Added support for Stop3 mode.
