Searched full:soldered (Results 1 – 13 of 13) sorted by relevance
| /Zephyr-latest/boards/shields/x_nucleo_53l0a1/doc/ |
| D | index.rst | 14 One VL53L0X is soldered on the expansion board itself. A set of spacers and
41 * **Center sensor** (soldered on the shield): ``VL53L0X_C``, 0x30
65 sensors (soldered + 2 satellites) and the 7 segments display.
|
| /Zephyr-latest/boards/shields/x_nucleo_53l0a1/ |
| D | x_nucleo_53l0a1.overlay | 22 /* Center sensor soldered on the shield */
|
| /Zephyr-latest/samples/shields/x_nucleo_53l0a1/ |
| D | README.rst | 19 the center sensor (soldered on the shield) is lower than 1.25m, then the
|
| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | espressif,esp32-pinctrl.yaml | 51 pull-up resistor soldered to GPIO_21's pin pad, in which case, 'bias-pull-up'
|
| /Zephyr-latest/boards/96boards/carbon/doc/ |
| D | nrf51822.rst | 83 soldered on first.
|
| /Zephyr-latest/boards/adafruit/nrf52_adafruit_feather/doc/ |
| D | index.rst | 94 needs to be soldered.
|
| /Zephyr-latest/boards/96boards/neonkey/doc/ |
| D | index.rst | 180 For flashing via SWD debug port, 0.1" male header must be soldered at P4
|
| /Zephyr-latest/boards/seco/stm32f3_seco_d23/doc/ |
| D | index.rst | 12 to 4GB LPDDR4-3200 32-bit bus memory directly soldered on board and one eMMC
|
| /Zephyr-latest/boards/blues/swan_r5/doc/ |
| D | index.rst | 17 can also be soldered directly to a parent PCB integrating those sensors,
|
| /Zephyr-latest/boards/seeed/lora_e5_mini/doc/ |
| D | index.rst | 40 - Flexible power-supply options: USB Type C or 3-5V battery soldered to +/- pins
|
| /Zephyr-latest/boards/st/nucleo_l4a6zg/doc/ |
| D | index.rst | 164 (HSE) is not soldered on the board, so it cannot be used to drive the PLL.
|
| /Zephyr-latest/boards/pine64/pinetime_devkit0/doc/ |
| D | index.rst | 132 Only a few devs have soldered to these pins, most just use friction to make
|
| /Zephyr-latest/boards/phytec/reel_board/doc/ |
| D | index.rst | 63 Since PCB version 1507.2, the nRF52840 SoC is not soldered directly to
|
