Home
last modified time | relevance | path

Searched +full:rgb +full:- +full:is +full:- +full:inverted (Results 1 – 10 of 10) sorted by relevance

/Zephyr-latest/dts/bindings/display/
Dsitronix,st7735r.yaml1 # Copyright (c) 2020, Kim Bøndergaard <kim@fam-boendergaard.dk>
2 # SPDX-License-Identifier: Apache-2.0
8 include: [mipi-dbi-spi-device.yaml, display-controller.yaml]
11 x-offset:
16 y-offset:
32 type: uint8-array
37 type: uint8-array
42 type: uint8-array
47 type: uint8-array
52 type: uint8-array
[all …]
Dsitronix,st7796s.yaml2 # SPDX-License-Identifier: Apache-2.0
8 include: [mipi-dbi-spi-device.yaml, display-controller.yaml]
12 type: uint8-array
19 type: uint8-array
26 type: uint8-array
33 type: uint8-array
40 type: uint8-array
47 type: uint8-array
69 type: uint8-array
75 type: uint8-array
[all …]
/Zephyr-latest/boards/shields/lcd_par_s035/boards/
Drd_rw612_bga.overlay4 * SPDX-License-Identifier: Apache-2.0
7 #include <zephyr/dt-bindings/mipi_dbi/mipi_dbi.h>
11 * - Depopulate resistors R78, R604, R598, R15, R245, R243, R11, R20, R237,
13 * - Populate resistors R286, R19, R246, R242, R123, R239, R124, R125, R236,
15 * - Remove jumper JP30
16 * - Set jumper JP40 to postion 1-2, JP38 to 1-2, and JP16 to position 2-3
21 * ON-ON-OFF (8 bit 8080 mode), and connect the following pins
23 * |-----------|-------------|----------|
62 slew-rate = "ultra";
67 mipi-mode = "MIPI_DBI_MODE_8080_BUS_8_BIT";
[all …]
/Zephyr-latest/boards/shields/frdm_cr20a/doc/
Dindex.rst3 NXP FRDM-CR20A
10 transceiver. The FRDM-CR20A evaluation board is a small, low-power,
11 cost-effective reference design for the MCR20A transceiver in a shield form
17 :alt: FRDM-CR20A
22 - MCR20AVHM
24 - Low-power
25 - High-performance 2.4 GHz IEEE 802.15.4 compliant transceiver
27 - Connectivity
29 - PCB inverted F-type antenna and SMA RF port
30 - Arduino compatible
[all …]
/Zephyr-latest/drivers/display/
Ddisplay_st7796s.c4 * SPDX-License-Identifier: Apache-2.0
33 bool inverted; /* Display color inversion */ member
57 const struct st7796s_config *config = dev->config; in st7796s_send_cmd()
59 return mipi_dbi_command_write(config->mipi_dbi, &config->dbi_config, in st7796s_send_cmd()
72 addr_data[1] = sys_cpu_to_be16(x + width - 1); in st7796s_set_cursor()
82 addr_data[1] = sys_cpu_to_be16(y + height - 1); in st7796s_set_cursor()
100 const struct st7796s_config *config = dev->config; in st7796s_get_pixelfmt()
103 * Invert the pixel format for 8-bit 8080 Parallel Interface. in st7796s_get_pixelfmt()
108 * For RGB565, Red is placed in byte 1 and Blue in byte 0. in st7796s_get_pixelfmt()
109 * For BGR565, Red is placed in byte 0 and Blue in byte 1. in st7796s_get_pixelfmt()
[all …]
/Zephyr-latest/boards/weact/mini_stm32h7b0/
Dmini_stm32h7b0.dts4 * SPDX-License-Identifier: Apache-2.0
7 /dts-v1/;
9 #include <st/h7/stm32h7b0vbtx-pinctrl.dtsi>
10 #include <zephyr/dt-bindings/input/input-event-codes.h>
11 #include <zephyr/dt-bindings/mipi_dbi/mipi_dbi.h>
15 compatible = "weact,mini-stm32h7b0";
19 zephyr,shell-uart = &usb_cdc_acm_uart;
26 compatible = "gpio-leds";
34 compatible = "gpio-keys";
43 compatible = "zephyr,mipi-dbi-spi";
[all …]
/Zephyr-latest/boards/sipeed/longan_nano/
Dlongan_nano-common.dtsi4 * SPDX-License-Identifier: Apache-2.0
7 #include <zephyr/dt-bindings/input/input-event-codes.h>
8 #include <zephyr/dt-bindings/mipi_dbi/mipi_dbi.h>
13 zephyr,shell-uart = &usart0;
21 compatible = "gpio-leds";
37 compatible = "gpio-keys";
46 compatible = "pwm-leds";
64 pwm-led0 = &pwm_led_green;
65 pwm-led1 = &pwm_led_blue;
71 compatible = "zephyr,mipi-dbi-spi";
[all …]
/Zephyr-latest/boards/weact/mini_stm32h743/
Dmini_stm32h743.dts4 * SPDX-License-Identifier: Apache-2.0
7 /dts-v1/;
9 #include <st/h7/stm32h743vitx-pinctrl.dtsi>
10 #include <zephyr/dt-bindings/input/input-event-codes.h>
11 #include <zephyr/dt-bindings/mipi_dbi/mipi_dbi.h>
15 compatible = "weact,mini-stm32h743";
24 compatible = "gpio-leds";
32 compatible = "gpio-keys";
41 compatible = "zephyr,mipi-dbi-spi";
42 spi-dev = <&spi4>;
[all …]
/Zephyr-latest/doc/releases/
Drelease-notes-2.2.rst9 This is a maintenance release for Zephyr 2.2 with fixes.
18 * Fix CVE-2020-10028
19 * Fix CVE-2020-10060
20 * Fix CVE-2020-10063
21 * Fix CVE-2020-10066
32 * :github:`23494` - Bluetooth: LL/PAC/SLA/BV-01-C fails if Slave-initiated Feature Exchange is disa…
33 * :github:`23485` - BT: host: Service Change indication sent regardless of whether it is needed or …
34 * :github:`23482` - 2M PHY + DLE and timing calculations on an encrypted link are wrong
35 * :github:`23070` - Bluetooth: controller: Fix ticker implementation to avoid catch up
36 * :github:`22967` - Bluetooth: controller: ASSERTION FAIL on invalid packet sequence
[all …]
Drelease-notes-3.3.rst14 * Introduced :ref:`USB-C <usbc_api>` device stack with PD (power delivery)
17 CMSIS-DSP as the default backend.
30 * CVE-2023-0359: Under embargo until 2023-04-20
32 * CVE-2023-0779: Under embargo until 2023-04-22
45 * Newlib nano variant is no longer selected by default when
46 :kconfig:option:`CONFIG_NEWLIB_LIBC` is selected.
66 removed in favor of new :dtcompatible:`zephyr,flash-disk` devicetree binding.
71 * Starting from this release ``zephyr-`` prefixed tags won't be created
81 is of the whole file being uploaded (different to the hash used when getting
82 image states). Use of a truncated hash or non-sha256 hash will still work
[all …]