Searched +full:pullup +full:- +full:ohm (Results 1 – 4 of 4) sorted by relevance
| /Zephyr-latest/tests/drivers/build_all/sensor/ |
| D | adc.dtsi | 5 * SPDX-License-Identifier: Apache-2.0
10 #include <zephyr/dt-bindings/battery/battery.h>
16 io-channels = <&test_adc 0>;
21 compatible = "voltage-divider";
22 io-channels = <&test_adc 1>;
23 io-channel-names = "VOLTAGE";
24 output-ohms = <47000>; /* R1 */
25 full-ohms = <(100000 + 47000)>; /* R2 + R1 */
26 power-gpios = <&test_gpio 0 0>;
31 compatible = "current-sense-amplifier";
[all …]
|
| /Zephyr-latest/dts/bindings/sensor/ |
| D | ntc-thermistor.yaml | 2 # SPDX-License-Identifier: Apache-2.0
6 include: [sensor-device.yaml]
9 io-channels:
14 pullup-uv:
17 The pullup voltage microvoltage in the circuit.
18 If not specified, it is assumed that the pullup voltage is VDD. Therefore,
22 pullup-ohm:
25 The pullup resistance in the circuit.
27 pulldown-ohm:
32 connected-positive:
[all …]
|
| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | nxp,mcux-rt-pinctrl.yaml | 2 # SPDX-License-Identifier: Apache-2.0
15 drive-strength = "r0-6";
16 slew-rate = "slow";
17 nxp,speed = "100-mhz";
21 Both pins will be configured with a weak latch, drive strength of "r0-6",
26 input-schmitt-enable: HYS=1
27 drive-open-drain: ODE=1
28 input-enable: SION=1 (in SW_MUX_CTL_PAD register)
29 bias-pull-down: PUE=1, PUS=<bias-pull-down-value>
30 bias-pull-up: PUE=1, PUS=<bias-pull-up-value>
[all …]
|
| /Zephyr-latest/boards/tdk/robokit1/ |
| D | robokit1-common.dtsi | 4 * SPDX-License-Identifier: Apache-2.0
7 #include "robokit1-pinctrl.dtsi"
14 die-temp0 = &icm42688;
15 ambient-temp0 = &temp_sensor;
20 zephyr,shell-uart = &uart2;
23 zephyr,code-partition = &slot0_partition;
27 compatible = "gpio-leds";
48 io-channels = <&spi_adc 0>;
49 pullup-uv = <3300000>;
50 pullup-ohm = <0>;
[all …]
|
