Searched full:moves (Results 1 – 25 of 38) sorted by relevance
12
| /Zephyr-latest/soc/intel/intel_adsp/ace/ |
| D | Kconfig.defconfig.series | 12 # MTL leaves the upper mapping in the same spot as cAVS, but moves the
|
| /Zephyr-latest/dts/bindings/w1/ |
| D | adi,max32-w1.yaml | 57 This mode moves the write one release, the data sampling,
|
| /Zephyr-latest/subsys/profiling/perf/backends/ |
| D | perf_x86_64.c | 71 * and trace moves deeper into the stack in arch_perf_current_stack_trace()
|
| D | perf_x86.c | 85 * and trace moves deeper into the stack in arch_perf_current_stack_trace()
|
| D | perf_riscv.c | 97 * and trace moves deeper into the stack in arch_perf_current_stack_trace()
|
| /Zephyr-latest/subsys/shell/ |
| D | shell_ops.h | 284 /* Moves cursor by defined number of words left (val negative) or right. */
295 /* Function moves cursor to begin of command position, just after console
300 /* Function moves cursor to end of command. */
|
| /Zephyr-latest/doc/services/shell/ |
| D | index.rst | 625 - Moves the cursor to the beginning of the line.
627 - Moves the cursor backward one character.
634 - Moves the cursor to the end of the line.
636 - Moves the cursor forward one character.
643 - Moves in history to next entry.
645 - Moves in history to previous entry.
652 - Moves the cursor backward one word.
654 - Moves the cursor forward one word.
|
| /Zephyr-latest/samples/sensor/jc42/ |
| D | README.rst | 16 When the temperature moves outside the window an alert is given, and the
|
| /Zephyr-latest/dts/bindings/display/ |
| D | sitronix,st7796s.yaml | 65 VCOM control setting. Value starts at 0.300V, and moves upwards in
|
| /Zephyr-latest/tests/bluetooth/common/testlib/include/testlib/ |
| D | conn.h | 89 * moves the reference into @ref bt_conn_unref.
|
| /Zephyr-latest/dts/bindings/ethernet/ |
| D | xlnx,gem.yaml | 94 Moves the handling of the frame received interrupt including the
105 Moves the handling of the frame transmission done interrupt into the
|
| /Zephyr-latest/subsys/demand_paging/eviction/ |
| D | lru.c | 20 * k_mem_paging_eviction_accessed() which moves the corresponding page frame
|
| /Zephyr-latest/doc/connectivity/bluetooth/api/mesh/ |
| D | blob_cli.rst | 86 Note that the BLOB Transfer Client only moves forward with the transfer in following cases:
|
| D | core.rst | 55 This moves the responsibility of storing RPL to the user application and
|
| /Zephyr-latest/include/zephyr/fs/ |
| D | fs_sys.h | 57 * Moves the file position to a new location in the file.
|
| /Zephyr-latest/subsys/net/ip/ |
| D | Kconfig.ipv6 | 219 moves from one network to another. This method is meant to be an
|
| /Zephyr-latest/tests/subsys/fs/common/ |
| D | test_fs_dirops.c | 236 /* f3f => d1f/d1f2t : moves */ in check_rename()
|
| /Zephyr-latest/subsys/bluetooth/controller/ll_sw/nordic/hal/nrf5/radio/ |
| D | radio_df.c | 96 * Each write stores a value and moves the pointer to new free position. in radio_df_ant_switch_pattern_set()
|
| /Zephyr-latest/subsys/net/lib/lwm2m/ |
| D | lwm2m_engine.h | 359 * @brief Moves all queued messages to pending.
|
| /Zephyr-latest/boards/ezurio/mg100/doc/ |
| D | index.rst | 133 Motion sensor to detect if the gateway moves.
|
| /Zephyr-latest/drivers/serial/ |
| D | uart_apbuart.c | 370 * holding register (or FIFO if implemented) moves from non-empty to in apbuart_irq_tx_enable()
|
| /Zephyr-latest/tests/lib/heap/src/ |
| D | main.c | 318 * it moves. in ZTEST()
|
| /Zephyr-latest/arch/xtensa/core/ |
| D | vector_handlers.c | 49 * moves execution to the interrupt stack when nested goes from in xtensa_is_outside_stack_bounds()
|
| /Zephyr-latest/include/zephyr/drivers/ |
| D | dai.h | 218 * This trigger frees resources and moves the driver back to initial
|
| D | auxdisplay.h | 41 /** Moves to specified X,Y position */
|
12
