| /Zephyr-latest/dts/bindings/mtd/ |
| D | atmel,at45.yaml | 61 When set, the driver will use the Ultra-Deep Power-Down command instead
62 of the default Deep Power-Down one to put the chip into low power mode.
65 SRAM buffers in the chip, the difference between the Deep and Ultra-Deep
73 Time, in nanoseconds, needed by the chip to enter the Deep Power-Down
74 mode (or Ultra-Deep Power-Down mode when the "use-udpd" property is set)
81 Time, in nanoseconds, needed by the chip to exit from the Deep Power-Down
82 mode (or Ultra-Deep Power-Down mode when the "use-udpd" property is set)
|
| D | jedec,spi-nor-common.yaml | 32 Use this property to indicate the flash chip supports the Deep
35 implies that the RDPD (0xAB) Release from Deep Power Down command
44 Some devices (Macronix MX25R in particular) wake from deep power
48 (1) tDPDD (Delay Time for Release from Deep Power-Down Mode)
49 (2) tCDRP (CSn Toggling Time before Release from Deep Power-Down Mode)
50 (3) tRDP (Recovery Time for Release from Deep Power-Down Mode)
53 used to wake the chip from Deep Power-Down mode.
62 deep power down.
73 deep power down and be ready to receive additional commands.
|
| /Zephyr-latest/tests/subsys/pm/power_mgmt_soc/src/ |
| D | power_mgmt.h | 11 /** @brief Alternates between light and deep sleep cycles.
16 * Similarly for deep sleep, the test sleeps in the main thread for 500 ms
24 /** @brief Alternates between light and deep sleep cycles.
26 * Performs same approach to achieve light and deep sleep, but additional
36 * Performs a dummy initialization for the board to enter light/deep sleep
|
| D | power_mgmt.c | 28 * and not accidentally into a deep sleep.
29 * - for deep sleep it can be very long as we want to ensure that we enter
250 /* Deep sleep cycle */ in test_pwr_mgmt_multithread()
251 /* Platforms that do not automatically enter deep sleep */ in test_pwr_mgmt_multithread()
256 LOG_INF("About to enter deep sleep"); in test_pwr_mgmt_multithread()
264 LOG_INF("Wake from Deep Sleep"); in test_pwr_mgmt_multithread()
299 /* Trigger Deep Sleep 1 state. 48MHz PLL off */ in test_pwr_mgmt_singlethread()
300 /* Platforms that do not automatically enter deep sleep */ in test_pwr_mgmt_singlethread()
303 LOG_INF("About to enter deep Sleep"); in test_pwr_mgmt_singlethread()
309 LOG_INF("Wake from Deep Sleep"); in test_pwr_mgmt_singlethread()
[all …]
|
| /Zephyr-latest/boards/shields/g1120b0mipi/boards/ |
| D | mimxrt595_evk_mimxrt595s_cm33.overlay | 7 /* Change deep sleep config for suspend mode to keep SMARTDMA ram powered,
8 * so the SMARTDMA will continue functioning after deep sleep
11 deep-sleep-config = <0xC800>,
|
| /Zephyr-latest/samples/boards/microchip/mec15xxevb_assy6853/power_management/src/ |
| D | power_mgmt.h | 11 /** @brief Alternates between light and deep sleep cycles.
16 * Similarly for deep sleep, the test sleeps in the main thread for 500 ms
26 /** @brief Alternates between light and deep sleep cycles.
28 * Performs same approach to achieve light and deep sleep, but additional
|
| D | power_mgmt.c | 66 * JP25.5 (GPIO013_DP) deep sleep
267 /* Ensure we can enter deep sleep when stopping threads in test_pwr_mgmt_multithread()
299 /* Deep sleep cycle */ in test_pwr_mgmt_multithread()
302 LOG_INF("About to enter deep sleep"); in test_pwr_mgmt_multithread()
304 /* GPIO toggle to measure latency for deep sleep */ in test_pwr_mgmt_multithread()
312 LOG_INF("Wake from Deep Sleep"); in test_pwr_mgmt_multithread()
314 printk("Wake from Deep Sleep\n"); in test_pwr_mgmt_multithread()
355 /* Trigger Deep Sleep 1 state. 48MHz PLL off */ in test_pwr_mgmt_singlethread()
356 LOG_INF("About to enter deep Sleep"); in test_pwr_mgmt_singlethread()
366 LOG_INF("Wake from Deep Sleep"); in test_pwr_mgmt_singlethread()
[all …]
|
| /Zephyr-latest/dts/bindings/power/ |
| D | nxp,pdcfg-power.yaml | 11 deep-sleep-config:
15 power to various blocks while the CPU is in deep sleep mode. These values
16 are programmed to the sleep configuration registers before entering deep
|
| /Zephyr-latest/soc/nuvoton/npcx/common/ |
| D | power.c | 23 * | Deep Sleep | On | Stop | Stop | Stop | Power Down | On | On |
32 * - A delay of 'Instant' wake-up from 'Deep Sleep' is 20 us.
33 * - A delay of 'Standard' wake-up from 'Deep Sleep' is 3.43 ms.
34 * - Max residency time in Deep Sleep for 'Instant' wake-up is 200 ms
35 * - Min Residency time in Deep Sleep for 'Instant' wake-up is 61 us
40 * Sub-state 0 - "Deep Sleep" mode with “Instant” wake-up if residency time
42 * Sub-state 1 - "Deep Sleep" mode with "Standard" wake-up if residency time
62 /* The steps that npcx ec enters sleep/deep mode and leaves it. */
104 * save power consumption when ec enter deep sleep.
151 /* Configure sleep/deep sleep settings in clock control module. */ in npcx_power_enter_system_sleep()
[all …]
|
| D | soc_clock.h | 176 * low-frequency timer before ec entered deep idle state.
182 * system timer by low-frequency timer after ec left deep idle state.
188 * @brief Function to get time ticks in system sleep/deep sleep state. The unit
196 * instruction, ec will enter sleep/deep sleep state for better power
199 * @param is_deep A boolean indicating ec enters deep sleep or sleep state
200 * @param is_instant A boolean indicating 'Instant Wake-up' from deep idle is
|
| /Zephyr-latest/samples/boards/espressif/deep_sleep/ |
| D | README.rst | 1 .. zephyr:code-sample:: esp32-deep-sleep
2 :name: Deep Sleep
4 Use deep sleep with wake on timer, GPIO, and EXT1 sources on ESP32.
9 The deep sleep mode of the ESP32 Series is a power saving mode that causes the
13 This sample shows how to set a wake up source, trigger deep sleep and then
28 as wake-up source, deep sleep for 20 seconds, wake up.
|
| D | sample.yaml | 2 description: Sample application to test ESP32 deep-sleep mode
3 name: ESP32 Deep-sleep
|
| D | Kconfig | 4 mainmenu "Espressif Deep Sleep demo"
11 This option enables wake-up from deep sleep using GPIO2 and
|
| /Zephyr-latest/soc/ite/ec/common/ |
| D | power.c | 11 /* Handle when enter deep doze mode. */
14 /* Enter deep doze mode */ in ite_power_soc_deep_doze()
24 /* Deep doze mode */ in pm_state_set()
|
| /Zephyr-latest/samples/boards/microchip/mec15xxevb_assy6853/power_management/ |
| D | README.rst | 10 It showcase simple app that allows to enter into light and deep sleep.
25 Wake from Deep Sleep
29 Wake from Deep Sleep
|
| /Zephyr-latest/soc/espressif/esp32/ |
| D | Kconfig | 35 int "Extra delay in deep sleep wake stub (in us)"
39 When ESP32 exits deep sleep, the CPU and the flash chip are powered on
40 at the same time. CPU will run deep sleep stub first, and then
50 console after deep sleep reset, try increasing this value.
|
| /Zephyr-latest/dts/bindings/timer/ |
| D | nxp,os-timer.yaml | 17 deep-sleep-counter:
21 certain deep power down modes. The OS Timer driver will use this
|
| /Zephyr-latest/soc/microchip/mec/mec172x/ |
| D | device_power.h | 16 * Disable UART deep sleep save/restore. If a UART TX FIFO has data on deep
26 * prior to deep sleep entry.
|
| D | power.c | 25 * Deep Sleep
65 * Enable deep sleep mode in CM4 and MEC172x. in z_power_soc_deep_sleep()
66 * Enable CM4 deep sleep and sleep signals assertion on WFI. in z_power_soc_deep_sleep()
142 * For deep sleep pm_system_suspend has executed all the driver
164 * >= numerical priority. MCHP z_power_soc_(deep)_sleep sets PRIMASK=1 and BASEPRI=0
|
| /Zephyr-latest/soc/microchip/mec/mec15xx/ |
| D | power.c | 17 * Deep Sleep
74 * after exiting deep sleep, so need to unmask exceptions in z_power_soc_deep_sleep()
102 * For deep sleep pm_system_suspend has executed all the driver
124 * preventing wake. MCHP z_power_soc_(deep)_sleep sets PRIMASK=1 and BASEPRI=0
|
| /Zephyr-latest/samples/boards/nordic/system_off/ |
| D | README.rst | 5 Use deep sleep on Nordic platforms.
11 deep sleep on Nordic platforms.
|
| /Zephyr-latest/soc/ambiq/apollo3x/ |
| D | power.c | 33 /* Put ARM core to deep sleep. */ in pm_state_set()
86 /* For optimal Deep Sleep current, configure cache to be powered-down in deepsleep. */ in ambiq_power_init()
89 /* Power off all flash area, when go to deep sleep.*/ in ambiq_power_init()
|
| /Zephyr-latest/soc/nxp/kinetis/ke1xf/ |
| D | power.c | 35 /* Set partial stop mode and enable deep sleep */ in pm_state_set()
59 /* Disable deep sleep upon exit */ in pm_state_exit_post_ops()
|
| /Zephyr-latest/soc/nxp/kinetis/ke1xz/ |
| D | power.c | 33 /* Set partial stop mode and enable deep sleep */ in pm_state_set()
56 /* Disable deep sleep upon exit */ in pm_state_exit_post_ops()
|
| /Zephyr-latest/samples/boards/espressif/light_sleep/ |
| D | prj.conf | 2 # Required to disable default behavior of deep sleep on timeout
|
