Home
last modified time | relevance | path

Searched full:dc (Results 1 – 25 of 31) sorted by relevance

12

/hal_espressif-latest/components/spi_flash/
Dspi_flash_hpm_enable.c190 * Usually, the bits are at bit-0, bit-1, sr-3 and set DC[1:0]=[1,1].
205 * @brief Check whether HPM has been enabled. This function checks the DC bits
226 #warning HPM-DC, which helps to run some flash > 80MHz by adjusting dummy cycles, is no longer enab…
328 ESP_EARLY_LOGI(HPM_TAG, "w/o HPM-DC support"); in spi_flash_enable_high_performance_mode()
331 ESP_EARLY_LOGI(HPM_TAG, "with HPM-DC support"); in spi_flash_enable_high_performance_mode()
334 …ESP_EARLY_LOGW(HPM_TAG, "HPM mode with DC adjustment is disabled. Some flash models may not be sup… in spi_flash_enable_high_performance_mode()
DKconfig66 prompt "Support HPM using DC (READ DOCS FIRST)"
70 …This feature needs your bootloader to be compiled DC-aware (BOOTLOADER_FLASH_DC_AWARE=y). Otherwis…
83 … This is a helper config for HPM. Whether HPM-DC is enabled is also determined by bootloader.
/hal_espressif-latest/components/hal/esp32s3/include/hal/
Dlcd_ll.h377 * @brief Set the level state of DC line, on different transaction phases
380 * @param idle_phase Level state of DC line on IDLE phase
381 * @param cmd_phase Level state of DC line on CMD phase
382 * @param dummy_phase Level state of DC line on DUMMY phase
383 * @param data_phase Level state of DC line on DATA phase
395 * @brief Set cycle of delay for DC line
/hal_espressif-latest/components/hal/esp32/include/hal/
Ddac_ll.h165 * Set the voltage value of the DC component of the cosine wave generator output.
167 * @note The DC offset setting should be after phase setting.
170 * @param offset DC value. Range: -128 ~ 127.
/hal_espressif-latest/components/hal/esp32s2/include/hal/
Ddac_ll.h186 * Set the voltage value of the DC component of the cosine wave generator output.
188 * @note The DC offset setting should be after phase setting.
191 * @param offset DC value. Range: -128 ~ 127.
/hal_espressif-latest/components/driver/deprecated/driver/
Ddac_types_legacy.h73 …int8_t offset; /*!< Set the voltage value of the DC component of the cosine wave generato…
/hal_espressif-latest/components/soc/esp32s2/include/soc/
Dsens_struct.h312 uint32_t dac_dc1: 8; /*DC offset for DAC1 CW generator*/
313 uint32_t dac_dc2: 8; /*DC offset for DAC2 CW generator*/
Dsens_reg.h1128 /*description: DC offset for DAC2 CW generator*/
1134 /*description: DC offset for DAC1 CW generator*/
/hal_espressif-latest/components/esp_hw_support/port/esp32s3/
Dmspi_timing_config.c122 if (spi_flash_hpm_dummy_adjust()) { // HPM-DC is enabled in spi_timing_config_get_dummy()
142 { // HPM-DC is not enabled in spi_timing_config_get_dummy()
/hal_espressif-latest/components/esp_phy/include/esp_private/
Dphy.h136 …* @attention 1.This is a workaround to improve Wi-Fi receive 11b pkts for some modules using AC-DC
/hal_espressif-latest/components/esp_rom/include/esp32c3/rom/
Dtjpgd.h73 SHORT dcv[3]; /* Previous DC element of each component */
/hal_espressif-latest/components/esp_rom/include/esp32c6/rom/
Dtjpgd.h78 SHORT dcv[3]; /* Previous DC element of each component */
/hal_espressif-latest/components/esp_phy/
DKconfig165 …This is a workaround to improve Wi-Fi receive 11b pkts for some modules using AC-DC power supply w…
/hal_espressif-latest/components/esp_rom/include/esp32s3/rom/
Dtjpgd.h73 SHORT dcv[3]; /* Previous DC element of each component */
/hal_espressif-latest/components/esp_rom/include/esp32/rom/
Dtjpgd.h73 SHORT dcv[3]; /* Previous DC element of each component */
/hal_espressif-latest/zephyr/esp32s3/src/
Dsoc_flash_init.c248 /* Reset flash, clear volatile bits DC[0:1]. Make it work under default mode to boot. */ in init_spi_flash()
/hal_espressif-latest/components/bootloader_support/bootloader_flash/src/
Dbootloader_flash_config_esp32s3.c264 // Reset flash, clear volatile bits DC[0:1]. Make it work under default mode to boot. in bootloader_init_spi_flash()
/hal_espressif-latest/zephyr/port/pincfgs/
Desp32s3.yml557 dc:
/hal_espressif-latest/components/bt/host/bluedroid/stack/btu/
Dbtu_hcif.c675 DEV_CLASS dc; in btu_hcif_connection_request_evt() local
679 STREAM_TO_DEVCLASS (dc, p); in btu_hcif_connection_request_evt()
685 btm_sec_conn_req (bda, dc); in btu_hcif_connection_request_evt()
690 btm_sco_conn_req (bda, dc, link_type); in btu_hcif_connection_request_evt()
/hal_espressif-latest/components/bt/host/bluedroid/stack/avct/
Davct_l2c.c357 AVCT_TRACE_DEBUG("ch_state dc: %d ", p_lcb->ch_state); in avct_l2c_disconnect_cfm_cback()
/hal_espressif-latest/components/bt/host/bluedroid/stack/btm/include/
Dbtm_int.h1044 void btm_acl_created (BD_ADDR bda, DEV_CLASS dc, UINT8 bdn[BTM_MAX_REM_BD_NAME_LEN],
1183 void btm_sec_conn_req (UINT8 *bda, UINT8 *dc);
/hal_espressif-latest/components/soc/esp32/include/soc/
Dsens_reg.h949 /*description: DC offset for DAC2 CW generator*/
955 /*description: DC offset for DAC1 CW generator*/
/hal_espressif-latest/components/bt/host/bluedroid/stack/btm/
Dbtm_inq.c1818 DEV_CLASS dc; in btm_process_inq_results() local
1844 STREAM_TO_DEVCLASS (dc, p); in btm_process_inq_results()
1935 p_cur->dev_class[0] = dc[0]; in btm_process_inq_results()
1936 p_cur->dev_class[1] = dc[1]; in btm_process_inq_results()
1937 p_cur->dev_class[2] = dc[2]; in btm_process_inq_results()
Dbtm_acl.c242 void btm_acl_created (BD_ADDR bda, DEV_CLASS dc, UINT8 bdn[BTM_MAX_REM_BD_NAME_LEN], in btm_acl_created() argument
306 if (dc) { in btm_acl_created()
307 memcpy (p->remote_dc, dc, DEV_CLASS_LEN); in btm_acl_created()
/hal_espressif-latest/components/bt/host/bluedroid/bta/dm/include/
Dbta_dm_int.h568 DEV_CLASS dc; member

12