Searched full:capacitor (Results 1 – 10 of 10) sorted by relevance
/Zephyr-Core-3.6.0/dts/bindings/input/ |
D | st,stmpe811.yaml | 68 Panel driver settling time (microseconds). For large panels (> 6"), a capacitor of 10 nF 71 around 1 ms. When a larger capacitor is used, this value should be changed, as it can 89 If no capacitor, or a smaller capacitor is used, this value can be lowered to
|
/Zephyr-Core-3.6.0/dts/bindings/sensor/ |
D | aosong,dht.yaml | 9 DHT11 uses a polymer humidity capacitor with NTC thermistor; the
|
/Zephyr-Core-3.6.0/samples/boards/esp32/light_sleep/ |
D | README.rst | 27 and a 100nF capacitor to ground for debouncing.
|
/Zephyr-Core-3.6.0/soc/arm/nordic_nrf/nrf53/ |
D | Kconfig.soc | 200 for each capacitor, 15 to get 7.5 pF, and so on.
|
D | soc.c | 544 * where CAPACITANCE is the desired capacitor value in pF, holding any in nordicsemi_nrf53_init()
|
/Zephyr-Core-3.6.0/drivers/ethernet/ |
D | dsa_ksz8xxx.c | 358 * 2) There may be a link-up issue in the capacitor AC coupling mode for port 369 * connection, or port to port with capacitor AC coupling connection, the signal 380 * solve the issue for all type of the short cables and the capacitor AC 406 * connection with the capacitor AC coupling mode. 497 * For the wider bandwidth cables or on-board capacitor AC coupling 509 * or connect two ports directly through capacitors for a capacitor
|
/Zephyr-Core-3.6.0/soc/arm/nordic_nrf/nrf54l/ |
D | soc.c | 64 * where CAPACITANCE is the desired capacitor value in pF, holding any in nordicsemi_nrf54l_init()
|
/Zephyr-Core-3.6.0/soc/xtensa/espressif_esp32/esp32s2/ |
D | Kconfig.soc | 76 Additionally, 1nF capacitor must be connected between 32K_XP pin and
|
/Zephyr-Core-3.6.0/soc/xtensa/espressif_esp32/esp32/ |
D | Kconfig.soc | 111 Additionally, 1nF capacitor must be connected between 32K_XP pin and
|
/Zephyr-Core-3.6.0/boards/arm/ronoth_lodev/doc/ |
D | s76s.rst | 146 …rs a reduced touch sensing sensitivity. It is thus recommended to use it as sampling capacitor I/O.
|