Searched full:automatic (Results 1 – 25 of 158) sorted by relevance
1234567
39 /* Automatic self reset.41 * Enable automatic self-reset function.
25 /** Automatic Baseline Correction Self Calibration Function. */
29 /* Set the initial period for automatic self calibration correction in hours. Allowed values34 /* Set the standard period for automatic self calibration correction in hours. Allowed
59 bool "Automatic acknowledge for eSPI HOST warnings"64 Enable automatic acknowledgment from eSPI target towards eSPI controller70 bool "Automatic acknowledge target boot status"75 Enable automatic acknowledgment from target basic configuration been
34 bool "Automatic security elevation and retry on security errors"72 bool "Automatic re-subscription to characteristics"85 bool "Automatic security re-establishment request as a peripheral"198 bool "Support to automatic discover the CCC handles of characteristics"212 bool "Automatic Update of Connection Parameters"
15 * @brief Configure the Automatic Freeze mode. If this mode is enabled, whenever
20 /** Automatic mode */
55 This enables support for 64-bytes FIFO and automatic hardware61 This enables support for 128-bytes FIFO and automatic hardware flow control.
106 * (both Automatic and Lazy state preservation is enabled). in z_arm_floating_point_init()110 * automatic stacking of FP registers (automatic setting of in z_arm_floating_point_init()123 * Enable both automatic and lazy state preservation of the FP context. in z_arm_floating_point_init()
37 Enable automatic detection of modem variant (SARA-R4 or SARA-U2)66 Enable automatic detection of the APN, based on the IMSI
66 automatic-gain-control:68 description: Automatic Gain Control capabilities
21 * enabled automatic reset has been disabled.
21 This flag disables the automatic reset, which allows the implementation
8 /* USART Wakeup requires automatic HSI16 switch on in deepsleep mode
9 /* USART Wakeup requires automatic HSI16 switch on in deepsleep mode
36 Enable automatic self-reset function.
14 semi-automatic way during the system boot, based on user-supplied74 If you want to use the network configuration library but without automatic
36 automatic-gain-control =67 automatic-gain-control =
18 In the future, with :ref:`sensor-read-and-decode` its possible that automatic management of device …
11 This test is not run in automatic test suites because it generally takes
62 * @brief The gain mode is manual only and cannot be changed to automatic.68 * @brief The gain mode is automatic only and cannot be changed to manual.80 * @brief The gain mode is automatic.350 /** The set automatic mode has completed */472 * @brief Set automatic only gain mode in Audio Input Control Service.474 * Using this function and enabling automatic only gain disables493 * @brief Set the input gain to automatic.
17 (automatic) use of the -semihosting-config switch when invoking it.
80 The time for which the module sleeps between consecutive printing of thread analysis in automatic83 The stack for thread analyzer automatic thread.
43 Enable automatic initialization of a NVS on a memory region that does
12 allows confirmation that the flash is working and that automatic power
