| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | nxp,imx8ulp-pinctrl.yaml | 31 found in the SoC datasheet. Note that the TRM refers to the
43 lower pad frequency). Note that the TRM refers to the "fast"
|
| /Zephyr-latest/dts/bindings/gpio/ |
| D | xlnx,ps-gpio.yaml | 18 Zynq-7000 (comp. Zynq-7000 TRM, chap. 14.1.2, p. 381):
24 ZynqMP (UltraScale) (comp. Ultrascale TRM, chap. 27, p. 769):
|
| /Zephyr-latest/boards/ti/cc3220sf_launchxl/ |
| D | dbghdr.c | 15 * in the CC3220 TRM: http://www.ti.com/lit/ug/swru465/swru465.pdf
|
| /Zephyr-latest/boards/ti/cc3235sf_launchxl/ |
| D | dbghdr.c | 15 * in the CC3220 TRM: http://www.ti.com/lit/ug/swru465/swru465.pdf
|
| /Zephyr-latest/drivers/pinctrl/ |
| D | pinctrl_imx_scu.c | 29 * values as specified in the TRM. in pinctrl_configure_pins()
|
| /Zephyr-latest/boards/arm/mps3/doc/ |
| D | index.rst | 343 - `MPS3 AN547 Technical Reference Manual (TRM)`_
344 - `MPS3 AN552 Technical Reference Manual (TRM)`_
345 - `MPS3 AN555 Technical Reference Manual (TRM)`_
346 - `MPS3 FPGA Prototyping Board Technical Reference Manual (TRM)`_
361 .. _MPS3 AN547 Technical Reference Manual (TRM):
364 .. _MPS3 AN552 Technical Reference Manual (TRM):
367 .. _MPS3 AN555 Technical Reference Manual (TRM):
370 .. _MPS3 FPGA Prototyping Board Technical Reference Manual (TRM):
|
| /Zephyr-latest/boards/nuvoton/numaker_m2l31ki/doc/ |
| D | index.rst | 46 More details about the supported peripherals are available in `M2L31 TRM`_
89 .. _M2L31 TRM:
|
| /Zephyr-latest/dts/bindings/dai/ |
| D | nxp,dai-sai.yaml | 92 1) Check the TRM and see if your SAI instance is multiline. If not then
105 1) Check the TRM and see if your SAI instance is multiline. If not then
|
| /Zephyr-latest/boards/nuvoton/numaker_pfm_m487/doc/ |
| D | index.rst | 49 More details about the supported peripherals are available in `M480 TRM`_
92 .. _M480 TRM:
|
| /Zephyr-latest/boards/nuvoton/numaker_pfm_m467/doc/ |
| D | index.rst | 49 More details about the supported peripherals are available in `M460 TRM`_
92 .. _M460 TRM:
|
| /Zephyr-latest/include/zephyr/dt-bindings/ethernet/ |
| D | xlnx_gem.h | 20 * the UltraScale TRM (UG1085), which mentions in chapter 34, section "Configure
|
| /Zephyr-latest/drivers/gpio/ |
| D | gpio_xlnx_ps_bank.h | 15 * Register address offsets: comp. Zynq-7000 TRM, ug585, chap. B.19
|
| /Zephyr-latest/boards/ti/sk_am62/doc/ |
| D | index.rst | 133 AM62x SK EVM TRM:
142 .. _AM62x SK EVM TRM:
|
| /Zephyr-latest/boards/infineon/xmc45_relax_kit/doc/ |
| D | index.rst | 62 More details about the supported peripherals are available in `XMC4500 TRM`_
116 .. _XMC4500 TRM:
|
| /Zephyr-latest/boards/infineon/xmc47_relax_kit/doc/ |
| D | index.rst | 65 More details about the supported peripherals are available in `XMC4700 TRM`_
118 .. _XMC4700 TRM:
|
| /Zephyr-latest/boards/ti/cc3220sf_launchxl/doc/ |
| D | index.rst | 42 Complete details of the CC3220SF SoC can be found in the `CC3220 TRM`_.
158 `CC3220 TRM`_ for details on the secure flash boot process.
272 .. _CC3220 TRM:
|
| /Zephyr-latest/boards/ti/cc3235sf_launchxl/doc/ |
| D | index.rst | 42 Complete details of the CC3235SF SoC can be found in the `CC3235 TRM`_.
158 `CC3235 TRM`_ for details on the secure flash boot process.
274 .. _CC3235 TRM:
|
| /Zephyr-latest/drivers/entropy/ |
| D | entropy_cc13xx_cc26xx.c | 43 /* Initialization as described in TRM section 18.6.1.2 */ in start_trng()
135 /* Interrupt service routine as described in TRM section 18.6.1.3.2 */ in entropy_cc13xx_cc26xx_isr()
|
| /Zephyr-latest/drivers/ieee802154/ |
| D | ieee802154_cc13xx_cc26xx_subg.c | 155 .rateWord = 131072, /* 200 kBit, see TRM, section 25.10.5.2, formula 15 */
157 .rxBw = 0x59, /* 310.8 kHz RX bandwidth, see TRM, section 25.10.5.2, table 25-183 */
165 .txPower = 0x013f, /* 14 dBm, see TRM 25.3.3.2.16 */
670 /* See IEEE 802.15.4 section 6.7.1 and TRM section 25.5.4.3 */
894 /* Setup circular RX queue (TRM 25.3.2.7) */ in drv_data_init()
897 /* Setup TX buffer (TRM 25.10.2.1.1, table 25-171) */ in drv_data_init()
|
| /Zephyr-latest/boards/arm/v2m_beetle/doc/ |
| D | index.rst | 193 For more details please refer to `Beetle Technical Reference Manual (TRM)`_.
253 .. _Beetle Technical Reference Manual (TRM):
|
| /Zephyr-latest/drivers/ethernet/ |
| D | eth_xlnx_gem.c | 191 * Initialization procedure as described in the Zynq-7000 TRM, in DT_INST_FOREACH_STATUS_OKAY()
291 * comp. Zynq-7000 TRM, Chapter B.18, p. 1289/1290. in eth_xlnx_gem_isr()
474 * Zynq-7000 TRM, the 'used' bits shall be cleared in reverse in eth_xlnx_gem_send()
741 * Controller reset sequence as described in the Zynq-7000 TRM, in eth_xlnx_gem_reset_hw()
782 * in the Zynq-7000 TRM, chapter 16.3.3, is not tackled here. This in eth_xlnx_gem_configure_clocks()
1101 * comp. Zynq-7000 TRM, p. 1278 ff. in eth_xlnx_gem_set_initial_dmacr()
1319 * Set initial RX BD data -> comp. Zynq-7000 TRM, Chapter 16.3.5, in eth_xlnx_gem_configure_buffers()
1348 * Set initial TX BD data -> comp. Zynq-7000 TRM, Chapter 16.3.5, in eth_xlnx_gem_configure_buffers()
|
| D | phy_xlnx_gem.c | 44 * MDIO read operation as described in Zynq-7000 TRM, in phy_xlnx_gem_mdio_read()
123 * MDIO write operation as described in Zynq-7000 TRM, in phy_xlnx_gem_mdio_write()
366 * advertisement configuration as described in Zynq-7000 TRM, chapter in phy_xlnx_gem_marvell_alaska_cfg()
926 * PHY detection as described in Zynq-7000 TRM, chapter 16.3.4, in phy_xlnx_gem_detect()
|
| /Zephyr-latest/drivers/counter/ |
| D | counter_esp32_rtc.c | 94 * ESP32 TRM v4.6 sec. 31.3.11 in counter_esp32_stop()
|
| /Zephyr-latest/boards/ti/msp_exp432p401r_launchxl/doc/ |
| D | index.rst | 45 More details about the supported peripherals are available in MSP432P4XX TRM
|
| /Zephyr-latest/boards/arm/mps2/doc/ |
| D | mps2_an385.rst | 226 For more details please refer to `MPS2 Technical Reference Manual (TRM)`_.
277 .. _MPS2 Technical Reference Manual (TRM):
|
