Searched full:proceeding (Results 1 – 25 of 26) sorted by relevance
12
91 * @retval -EBUSY If i2c transaction is proceeding.103 * @retval -EBUSY If i2c transaction is proceeding.
9 Proceeding counter-clockwise:
12 Proceeding counter-clockwise:
10 Proceeding counter-clockwise:
11 Proceeding counter-clockwise:
236 /* Make sure that all the registers are set before proceeding */ in arm_core_mpu_enable()255 /* Make sure that all the registers are set before proceeding */ in arm_core_mpu_disable()274 /* Make sure that all the registers are set before proceeding */ in arm_core_mpu_enable()
464 /* Make sure that all the registers are set before proceeding */ in arm_core_mpu_enable()
108 As a maintainer, these are the steps required before proceeding with the merge process:
180 /* Apply remapping before proceeding with pin configuration */ in stm32_pins_remap()
119 before proceeding. These instructions were tested with version 6.1.0.
197 checkout to a branch that supports this interface, before proceeding.
95 "Please rewrite the app accordingly before proceeding"); in validate_hw_compatibility()101 "Please rewrite the app accordingly before proceeding"); in validate_hw_compatibility()
599 "Please rewrite the app accordingly before proceeding\n"); in validate_hw_compatibility()605 "Please rewrite the app accordingly before proceeding\n"); in validate_hw_compatibility()
436 /* Enable the LPTIM before proceeding with configuration */ in sys_clock_driver_init()
382 * have a valid link id before proceeding. in esp_sendto()
129 device. Make sure ``nrfutil`` is installed before proceeding.
252 * We have to test several requirements before proceeding with the reassembly: in fragments_are_ready()
388 * We have to test several requirements before proceeding with the reassembly: in fragments_are_ready()
479 being run by a handler. Proceeding to manipulate state shared with the work
669 /* Verify FS BIST before proceeding */ in wdt_nxp_fs26_init()
662 '''Require that a program is installed before proceeding.
322 return "proceeding"; in hawkbit_status_execution()
267 LOG_DBG("Proceeding with pending IV Update"); in seg_tx_reset()
750 * proceeding to the next state.
261 LOG_DBG("Proceeding with pending IV Update"); in seg_tx_reset()
