Searched full:ldos (Results 1 – 12 of 12) sorted by relevance
/Zephyr-latest/dts/bindings/power/ |
D | st,stm32wb0-pwr.yaml | 19 - LDOs supply voltage: VDD 30 - LDOs supply voltage: VDD (though SMPS) 31 - Current supplied to LDOs can be limited 36 - LDOs supply voltage: regulated SMPS output
|
/Zephyr-latest/dts/bindings/regulator/ |
D | maxim,max20335-regulator.yaml | 7 The PMIC has two buck converters and three LDOs. All need to be defined as
|
D | nordic,npm6001-regulator.yaml | 7 The PMIC has four buck converters and two LDOs. All need to be defined as
|
D | x-powers,axp192-regulator.yaml | 8 The PMIC has three DCDC converters and two LDOs (LDO1 cannot be disabled).
|
D | nordic,npm1300-regulator.yaml | 7 The PMIC has two buck converters and two LDOs.
|
D | nxp,pca9420.yaml | 7 The PMIC has two buck converters and two LDOs. All need to be defined as
|
/Zephyr-latest/soc/renesas/smartbond/da1469x/ |
D | soc.c | 178 * switching power sources, that is DCDC <--> LDOs <--> Retention LDOs. in soc_early_init_hook()
|
/Zephyr-latest/soc/nxp/imxrt/imxrt10xx/ |
D | power.c | 170 /* Enable regulator LDOs */ in lpm_raise_voltage() 173 /* Disable weak LDOs */ in lpm_raise_voltage()
|
/Zephyr-latest/drivers/regulator/ |
D | regulator_axp192.c | 312 /* AUTO is default mode for LDOs that cannot be configured */ in axp192_set_mode()
|
D | regulator_npm1300.c | 96 /* Linear range for output voltage, common for all bucks and LDOs on this device */
|
/Zephyr-latest/drivers/ieee802154/ |
D | ieee802154_dw1000_regs.h | 1244 /* Turn on power all LDOs */
|
/Zephyr-latest/boards/adi/max32675evkit/doc/ |
D | index.rst | 308 and (D8) illuminate when the 3V3, 1V8, and 1V0 LDOs are powered, respectively.
|