Searched full:j9 (Results 1 – 25 of 27) sorted by relevance
12
10 - Short BCLK J9-pin1 (SAI1_RX_BCLK) to J66-pin1 (SAI4_TX_BCLK)11 - Short SYNC J9-pin5 (SAI1_RX_SYNC) to J64-pin1 (SAI4_TX_SYNC)
8 * PWM signal is visible on J9-16.
22 * - Connect LPADC0 CH0 signal to voltage between 0~1.8V (J9 pin 10)
23 * - Connect LPADC0 CH0 signal to voltage between 0~1.8V (J9 pin 10)
22 * (Resistors J8 and J9, should be populated by default)
22 J9 GPIO48 48 GPIO70 70
37 8. External power supply connector (J9)
91 the jumpers ``J2`` and ``J9``. A trigger option also must be enabled in Kconfig
131 or J9 SWD connector.
133 or J9 SWD connector.
122 Attach a J-Link 10-pin connector to J14. Check that jumpers J8 and J9 are
199 or J9 SWD connector.
44 8. External power supply connector (J9)
167 Connect a USB cable from your PC to J9, and use the serial terminal of your choice
34 * J9 : Open
223 For the RT1040, J9/J10 are the SWD isolation jumpers, J12 is the DFU
191 Auxiliary (J9)
197 Auxiliary (J9)
193 Auxiliary (J9)
124 J9 Pinout
220 Auxiliary (J9)
222 Auxiliary (J9)
