Searched full:gpio3 (Results 1 – 25 of 66) sorted by relevance
123
| /Zephyr-Core-3.6.0/boards/arm/xmc47_relax_kit/ |
| D | arduino_r3_connector.dtsi | 28 <16 0 &gpio3 10 0>, /* D10 */
29 <17 0 &gpio3 8 0>, /* D11 */
30 <18 0 &gpio3 7 0>, /* D12 */
31 <19 0 &gpio3 9 0>, /* D13 */
32 <20 0 &gpio3 15 0>, /* D14 */
49 &gpio3 {
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1040_evk/ |
| D | mimxrt1040_evk.dts | 68 <6 0 &gpio3 1 0>, /* D0 */
69 <7 0 &gpio3 0 0>, /* D1 */
71 <9 0 &gpio3 2 0>, /* D3 */
78 <16 0 &gpio3 13 0>, /* D10 */
79 <17 0 &gpio3 14 0>, /* D11 */
80 <18 0 &gpio3 15 0>, /* D12 */
81 <19 0 &gpio3 12 0>, /* D13 */
|
| /Zephyr-Core-3.6.0/dts/bindings/sound/ |
| D | cirrus,cs47l63.yaml | 34 gpio3-gpios:
37 GPIO3 input with bus-keeper
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1024_evk/ |
| D | mimxrt1024_evk.dts | 137 scl-gpios = <&gpio3 22 GPIO_ACTIVE_HIGH>;
138 sda-gpios = <&gpio3 23 GPIO_ACTIVE_HIGH>;
188 cd-gpios = <&gpio3 19 GPIO_ACTIVE_LOW>;
189 pwr-gpios = <&gpio3 30 GPIO_ACTIVE_HIGH>;
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1015_evk/ |
| D | mimxrt1015_evk.dts | 36 gpios = <&gpio3 21 GPIO_ACTIVE_LOW>;
61 <6 0 &gpio3 1 0>, /* D0 */
62 <7 0 &gpio3 0 0>, /* D1 */
65 <10 0 &gpio3 2 0>, /* D4 */
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt595_evk/ |
| D | mimxrt595_evk_cm33.dts | 65 gpios = <&gpio3 17 0>;
115 <21 0 &gpio3 21 0>, /* Pin 21, RESET */
116 <22 0 &gpio3 18 0>, /* Pin 22, LPTE */
120 <29 0 &gpio3 19 0>, /* Pin 29, CTP_INT */
121 <32 0 &gpio3 15 0>, /* Pin 32, PWR_EN */
128 enable-gpios = <&gpio3 15 GPIO_ACTIVE_HIGH>;
295 * a given module. On this board, GPIO3 and GPIO4 are configured to support
298 &gpio3 {
|
| /Zephyr-Core-3.6.0/drivers/gpio/ |
| D | Kconfig.ads114s0x | 16 The GPIO port of the ADS114S0x (GPIO0 to GPIO3) is exposed as a
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1020_evk/ |
| D | mimxrt1020_evk.dts | 82 <20 0 &gpio3 23 0>, /* D14 */
83 <21 0 &gpio3 22 0>; /* D15 */
188 cd-gpios = <&gpio3 19 GPIO_ACTIVE_LOW>;
189 pwr-gpios = <&gpio3 24 GPIO_ACTIVE_HIGH>;
|
| /Zephyr-Core-3.6.0/boards/arm/mimx8mp_evk/ |
| D | mimx8mp_evk_ddr.dts | 33 &gpio3 {
|
| D | mimx8mp_evk_itcm.dts | 33 &gpio3 {
|
| /Zephyr-Core-3.6.0/dts/bindings/gpio/ |
| D | raspberrypi,pico-header.yaml | 15 3 GPIO3 3V3_OUT -
|
| D | raspberrypi-40pins-header.yaml | 13 1 GPIO3/I2C1_SCL GND -
|
| D | ambiq-header.yaml | 44 GPIO3 3 GPIO4 4
|
| /Zephyr-Core-3.6.0/boards/arm/verdin_imx8mp_m7/ |
| D | verdin_imx8mp_m7_ddr.dts | 27 &gpio3 {
|
| D | verdin_imx8mp_m7_itcm.dts | 27 &gpio3 {
|
| /Zephyr-Core-3.6.0/drivers/mfd/ |
| D | mfd_axp192.c | 118 /* GPIO3 */
210 /* GPIO3 */ in mfd_axp192_gpio_func_get()
318 /* GPIO3 */ in mfd_axp192_gpio_func_ctrl()
432 /* Configure pull-down. Pull-down is only supported by GPIO3 and GPIO4 */ in mfd_axp192_gpio_pd_ctrl()
490 /* read gpio3-4 */ in mfd_axp192_gpio_read_port()
532 /* Write gpio3-4. Mask out other port pins */ in mfd_axp192_gpio_write_port()
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1050_evk/ |
| D | mimxrt1050_evk.dts | 88 <16 0 &gpio3 13 0>, /* D10 */
89 <17 0 &gpio3 14 0>, /* D11 */
90 <18 0 &gpio3 15 0>, /* D12 */
91 <19 0 &gpio3 12 0>, /* D13 */
|
| /Zephyr-Core-3.6.0/boards/arm/qemu_cortex_m3/ |
| D | qemu_cortex_m3.dts | 59 &gpio3 {
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1064_evk/ |
| D | mimxrt1064_evk.dts | 96 <16 0 &gpio3 13 0>, /* D10 */
97 <17 0 &gpio3 14 0>, /* D11 */
98 <18 0 &gpio3 15 0>, /* D12 */
99 <19 0 &gpio3 12 0>, /* D13 */
|
| /Zephyr-Core-3.6.0/boards/arm/mimxrt1060_evk/ |
| D | mimxrt1060_evk.dts | 95 <16 0 &gpio3 13 0>, /* D10 */
96 <17 0 &gpio3 14 0>, /* D11 */
97 <18 0 &gpio3 15 0>, /* D12 */
98 <19 0 &gpio3 12 0>, /* D13 */
|
| /Zephyr-Core-3.6.0/boards/arm/vmu_rt1170/ |
| D | vmu_rt1170.dts | 132 &gpio3 {
211 int-gpios = <&gpio3 19 GPIO_ACTIVE_HIGH>;
222 cs-gpios =<&gpio3 24 GPIO_ACTIVE_LOW>;
245 int-gpios = <&gpio3 20 GPIO_ACTIVE_HIGH>;
|
| /Zephyr-Core-3.6.0/drivers/ieee802154/ |
| D | ieee802154_cc1200.h | 29 * GPIO3 -> GPIO3
|
| /Zephyr-Core-3.6.0/boards/arm/mps2_an521/ |
| D | pinmux.c | 25 * Pins 48 - 51 are for GPIO3
38 ((volatile struct gpio_cmsdk_ahb *)DT_REG_ADDR(DT_NODELABEL(gpio3)))
|
| /Zephyr-Core-3.6.0/boards/arm/mps2_an385/ |
| D | pinmux.c | 25 * Pins 48 - 51 are for GPIO3
38 ((volatile struct gpio_cmsdk_ahb *)DT_REG_ADDR(DT_NODELABEL(gpio3)))
|
| /Zephyr-Core-3.6.0/dts/arm/infineon/ |
| D | xmc4500_F100x1024.dtsi | 69 gpio3: gpio@48028300 { label
|
123
